Quatech user manual QSP-100 Client Driver for DOS, Client Driver Installation

2.1 QSP-100 Client Driver for DOS

In order to use the QSP-100 Client Driver, the system must be configured with Card and Socket Services software. Card and Socket Services software is not provided with the QSP-100 but is available from Quatech.

IMPORTANT:

Some versions of Card and Socket Services dated before 1993 do not support general purpose I/O cards. If after careful instal- lation of the Client Driver the QSP-100 does not configure or operate properly, an updated version of Card and Socket Services may be required. Card and Socket Services software is available from Quatech Inc.

2.2 Client Driver Installation

The following procedure is used to install the QSP-100 Client Driver:

1.Copy the file QSP100CL.SYS from the QSP-100 distribution Quatech COM CD onto the system's hard drive.

2.Using an ASCII text editor, open the system's CONFIG.SYS file located in the root directory of the boot drive.

3.Locate the line(s) in the CONFIG.SYS file where the Card and Socket Services software is installed.

4.AFTER the line(s) installing the Card and Socket Services software, add the following line to the CONFIG.SYS file:

DEVICE = drive:\path\QSP100CL.SYS

options

where options are the QSP-100 Client Driver command line options discussed on the following pages.

5. Save the CONFIG.SYS file and exit the text editor.

QSP-100 Users Manual 6