Patton electronic 3088 user manual Help Commands, System Conﬁguration Commands

Page 20

Help Commands

The following commands are provided to help the user ﬁnd the correct command:

•help: Lists all the commands that the console recognizes.

•system help: Lists all the commands that start with system that the console recognizes.

•system set help: Lists all the commands that start with system set that the console recognizes.

•system show help: Lists all the commands that start with system show that the console recognizes.

•dsl help: Lists all the commands that start with dsl that the console recognizes.

•dsl set help: Lists all the commands that start with dsl set that the console recognizes.

•dsl show help: Lists all the commands that start with dsl show that the console recognizes.

•dsl show errcntr help: Lists all the commands that start with dsl show errcntr that the console recognizes.

System Conﬁguration Commands

The following commands allow the user to conﬁgure the system:

•system set password <password>: Sets the system password.

•system set circuitid <circuitid>: Sets the circuit ID.

•system set timeslots <1–72>:Sets the number of DSL timeslots. The data rate is calculated by 64K x timeslots.

20

Image 20

Contents User Manual Contents Operation Remote Console Manual InformationCompliance Information Radio and TV Interference FCC Part 68 Acta StatementIndustry Canada Notice CE NoticeTel +1 301 Email support@patton.com Warranty InformationService Description FeaturesGeneral Information Configuration Model 3088 3088/D version shownParameter Description Possible Default Values OFF, LAL Parameter Description Possible Default Configuring the DIP SwitchesSystem Reset Mode Software UpgradesPosition Function Factory Default Conﬁguration Reset to Factory DefaultsDIP Switch Settings S1-7 S1-6 S1-5 S1-4 S1-3 S1-2 S1-1 Data Rate Kbps S1-8 TX Clock Setting DescriptionS1-7 S1-1 Data Rate 1920 S2-6 Setting S2-5 S2-4 Clock ModeS2-5 S2-4 Clock Mode Description LoopsS2-1 Front Panel Switches S2-3 Annex A/BS2-3 Annex S2-2 Line ProbePage DSL Line Condition Good or Poor CRCHelp Commands System Conﬁguration CommandsSystem show clockmode Shows the clock mode System Status CommandsDSL Conﬁguration Commands Startup Delay Interval Interval totintDSL Status Commands Page Example Command Line Interface Session Remote ConsoleRocketlink Plug ‘N’ Play 3096RC Installation Connecting the Twisted Pair InterfaceConnecting the Model 3088/CA Serial Interface Connecting the Model 3088/CA V.35 to a DTE DeviceConnecting the Model 3088/D X.21 to a DCE or DTE Device Connecting the Model 3088/CA V.35 to a DCE DeviceConnecting the Model 3088/D X.21 Serial Interface Connecting the Model 3088/D to X.21 DTE or DCE Opening the CaseConnecting Power POWER-UP Power GreenOperation LED Status MonitorsTerm Green 3088/D with the X.21 interfaceTM/ER Red Test ModesLocal Analog Loopback diagram PatternsEstablishing a Remote Console Session How to ConnectRemote Console Manual Information Page System show status command shows that DSL link is not up How to DisconnectDifferences in Local and Remote Control Session Behavior LAL Model 3088 Software Upgrade Feature Reset Configuration to Factory Defaults Serial Connector DiagnosticsAppendix a Clocking ModesPower ComplianceTransmission Line Line CodingEnvironment Line Interface14 G.SHDSL Physical Connection Appendix B Model # DescriptionPin # Signal Appendix CPin Signal Appendix D