Patton electronic 3088 user manual

Page 37

If 3088 (Far End) already has an active remote console session open, you will see the message Console: Remote console con- nection request rejected. This can also happen if the remote 3088 (far-end) has an established remote console session with the local 3088 (near-end) which has timed out.

6.Enter the password at the password prompt for the remote console session.

Note The passwords for a local console session of the 3088 (near- end) and the remote console session of the 3088 (far-end) should be different for the purpose of security.

7.You should now be logged into the remote 3088(far-end) via the remote console session. The communication with the remote 3088 (far-end) is essentially the same as having a local

console connection.

Note The local or remote 3088 may be CO or CPE, as long as there is one of each. Either the CO or CPE unit may accept a remote console connection.

Note With a remote console session open, a user at PC (far-end) is blocked from using the local console. Upon typing anything, the 3088 (far-end) sends a message to the PC (far-end) stating “Console: Remote console connection is open.”

37

Image 37
Contents User Manual Contents Remote Console Manual Information OperationFCC Part 68 Acta Statement Compliance Information Radio and TV InterferenceCE Notice Industry Canada NoticeService Warranty InformationTel +1 301 Email support@patton.com General Information FeaturesDescription Model 3088 3088/D version shown ConfigurationParameter Description Possible Default Values OFF, LAL Configuring the DIP Switches Parameter Description Possible DefaultSoftware Upgrades System Reset ModeDIP Switch Settings Configuration Reset to Factory DefaultsPosition Function Factory Default S1-7 S1-1 Data Rate S1-8 TX Clock Setting DescriptionS1-7 S1-6 S1-5 S1-4 S1-3 S1-2 S1-1 Data Rate Kbps 1920 S2-5 S2-4 Clock Mode S2-6 SettingS2-5 S2-4 Clock Mode Description LoopsS2-3 Annex A/B S2-1 Front Panel SwitchesS2-3 Annex S2-2 Line ProbePage CRC DSL Line Condition Good or PoorSystem Configuration Commands Help CommandsSystem Status Commands System show clockmode Shows the clock modeStartup Delay Interval Interval totint DSL Configuration CommandsDSL Status Commands Page Remote Console Example Command Line Interface SessionRocketlink Plug ‘N’ Play 3096RC Connecting the Twisted Pair Interface InstallationConnecting the Model 3088/CA V.35 to a DTE Device Connecting the Model 3088/CA Serial InterfaceConnecting the Model 3088/D X.21 Serial Interface Connecting the Model 3088/CA V.35 to a DCE DeviceConnecting the Model 3088/D X.21 to a DCE or DTE Device Opening the Case Connecting the Model 3088/D to X.21 DTE or DCEConnecting Power Power Green POWER-UPOperation LED Status Monitors3088/D with the X.21 interface Term GreenTM/ER Red Test ModesPatterns Local Analog Loopback diagramRemote Console Manual Information How to ConnectEstablishing a Remote Console Session Page How to Disconnect System show status command shows that DSL link is not upDifferences in Local and Remote Control Session Behavior LAL Model 3088 Software Upgrade Feature Reset Configuration to Factory Defaults Diagnostics Serial ConnectorAppendix a Clocking ModesCompliance PowerTransmission Line Line Coding14 G.SHDSL Physical Connection Line InterfaceEnvironment Model # Description Appendix BAppendix C Pin # SignalAppendix D Pin Signal