Patton electronic 4960 Series manual E1 PRI

SmartNode 4960 Getting Started Guide C • Cabling

E1 PRI

The E1 PRI is usually connected to a PBX or switch—local exchange (LE). Type and pin outs of these devices vary depending on the manufacturer. In most cases, a straight-through RJ-45 to RJ-45 can be used to connect the PRI with a PBX. A cross-over cable is required to connect to an NT device, as illustrated in figure 13 on page 58.

Hazardous network voltages are present in the PRI cables. If you detach the cable, detach the end away from the SmartNode or interface card first to avoid

possible electric shock. Network hazardous voltages may be present on the WARNING device in the area of the PRI port, regardless of when power is turned OFF.

To prevent damage to the system, make certain you connect the

PRI cable to the PRI port only and not to any other RJ-45 socket.

WARNING

NT

Figure 13. Connecting an E1 PRI port to an NT1

RJ-48C, male			RJ-48C, male
RX Ring	1	1	RX Ring
RX Tip	2	2	RX Tip
RX Shield	3	3	RX Shield
TX Ring	4	4	TX Ring
TX Tip	5	5	TX Tip
TX Shield	6	6	TX Shield
N/C	7	7	N/C
N/C	8	8	N/C
		*N/C = No connection*

Figure 14. E1 PRI port crossover cable

E1 PRI 58