KTI Networks KCD-400 Series manual DIN-Rail Mounting

Page 15

2.3 DIN-Rail Mounting

In the product package, a DIN-rail bracket is installed on the device for mounting the converter in a industrial DIN-rail enclosure.

The steps to mount the device onto a DIN rail are:

1. Install the mounting bracket onto the device unit as shown below:

2.Attach bracket to the lower edge of the DIN rail and push the unit upward a little bit until the bracket can clamp on the upper edge of the DIN rail.

3.Clamp the unit to the DIN rail and make sure it is mounted securely.

4.Make sure that there are proper heat dissipation from and adequate ventilation around the device.

-15-

Image 15

Contents Media Converters 1000BASE-T to 1000BASE-XInternational United StatesEthernet is a registered trademark of Xerox Corp Table of Contents Introduction Features Specifications LEDIndicators Twisted-Pair Interface Copper PortFiber Optic Interface Fiber Port Environmental DC Power InterfaceBasic Information MechanicalCE/EMC CertificateLink Fault Pass Through Function Special FunctionsAutoMDI/MDI-XFunction Far End Fault Function Unpacking InstallationSafety Cautions DIN-Rail Mounting Page Panel Mounting Screw locations and final dimension are shown below Using Terminal Blocks Applying PowerPage Using DC Power Jack Power Failure Relay Output Network Cables Making Twisted Pair Copper Port ConnectionInstalling SFP Fiber Transceiver Connecting Fiber CablesMaking Fiber Port Connection LED Indicators Model Specifications Appendix Model Optical Specifications