KTI Networks KCD-400 Series manual LED Indicators

Page 25

3 LED Indicators

The following figure shows the locations of the configuration switches and LED indicators:

3.1 LED Indicators

LED	DISPLAY	STATE	INTERPRETATION
PWR	Power status	ON	The device is powered on.
		OFF	The device is powered off.
SFP	SFP slot status	ON	An SFP transceiver is installed.
		OFF	No SFP transceiver is installed.
LINK	Link status	ON	Copper-fiber link up
		OFF	Copper-fiber link down
		BLINK	Copper-fiber link with data traffic
OL	Optical status	ON	Fiber port optical signal detected
		OFF	Fiber port no optical signal

-25-

Image 25

Contents Media Converters 1000BASE-T to 1000BASE-XInternational United StatesEthernet is a registered trademark of Xerox Corp Table of Contents Introduction Features Specifications Twisted-Pair Interface Copper Port LEDIndicatorsFiber Optic Interface Fiber Port Basic Information DC Power InterfaceMechanical EnvironmentalCE/EMC CertificateSpecial Functions Link Fault Pass Through FunctionAutoMDI/MDI-XFunction Far End Fault Function Unpacking InstallationSafety Cautions DIN-Rail Mounting Page Panel Mounting Screw locations and final dimension are shown below Using Terminal Blocks Applying PowerPage Using DC Power Jack Power Failure Relay Output Network Cables Making Twisted Pair Copper Port ConnectionConnecting Fiber Cables Installing SFP Fiber TransceiverMaking Fiber Port Connection LED Indicators Model Specifications Appendix Model Optical Specifications