KTI Networks KCD-400 Series manual Ethernet is a registered trademark of Xerox Corp

Page 3

The information contained in this document is subject to change without prior notice. Copyright (C) All Rights Reserved.

TRADEMARKS

Ethernet is a registered trademark of Xerox Corp.

FCC NOTICE

This device complies with Class B Part 15 the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received including the interference that may cause.

CE NOTICE

Marking by the symbol indicates compliance of this equipment to

the EMC directive of the European Community. Such marking is indica- tive that this equipment meets or exceeds the following technical stan- dards:

EMC Class B

EN 50081-1/1992 : EN55022:1994/A1:1995/A2:1997 Class B EN61000-3-2:2000 EN61000-3-3:1995/A1:2001

EN 55024:1998/A1:2001

IEC 61000-4-2:1995

IEC 61000-4-3:1995

IEC 61000-4-4:1995

IEC 61000-4-5:1995

IEC 61000-4-6:1996

IEC 61000-4-8:1993

IEC 61000-4-11:1994

Image 3

Contents Media Converters 1000BASE-T to 1000BASE-XInternational United StatesEthernet is a registered trademark of Xerox Corp Table of Contents Introduction Features Specifications LEDIndicators Twisted-Pair Interface Copper PortFiber Optic Interface Fiber Port Environmental DC Power InterfaceBasic Information MechanicalCE/EMC CertificateLink Fault Pass Through Function Special FunctionsAutoMDI/MDI-XFunction Far End Fault Function Unpacking InstallationSafety Cautions DIN-Rail Mounting Page Panel Mounting Screw locations and final dimension are shown below Using Terminal Blocks Applying PowerPage Using DC Power Jack Power Failure Relay Output Network Cables Making Twisted Pair Copper Port ConnectionInstalling SFP Fiber Transceiver Connecting Fiber CablesMaking Fiber Port Connection LED Indicators Model Specifications Appendix Model Optical Specifications