KTI Networks KCD-400 Series manual

Page 20

Power wires: 24 ~ 12AWG(IEC 0.5~2.5mm2)

Install the power source wires with the plug properly. Screw the wire with plug securely. Then, plug in DC1 contacts.

If cascading the power to next device is needed, install the power wires and plug for another switch. Then, use DC2 contacts.

Note: Only up to four device units can be cascaded to receive power from one main power input source.

-20-

Image 20

Contents 1000BASE-T to 1000BASE-X Media ConvertersUnited States InternationalEthernet is a registered trademark of Xerox Corp Table of Contents Introduction Features Specifications Fiber Optic Interface Fiber Port LEDIndicatorsTwisted-Pair Interface Copper Port DC Power Interface Basic InformationMechanical EnvironmentalCertificate CE/EMCAutoMDI/MDI-XFunction Link Fault Pass Through FunctionSpecial Functions Far End Fault Function Installation UnpackingSafety Cautions DIN-Rail Mounting Page Panel Mounting Screw locations and final dimension are shown below Applying Power Using Terminal BlocksPage Using DC Power Jack Power Failure Relay Output Making Twisted Pair Copper Port Connection Network CablesMaking Fiber Port Connection Installing SFP Fiber TransceiverConnecting Fiber Cables LED Indicators Appendix Model Optical Specifications Model Specifications