Canon 7585 manual Filter button, Blank button, Mouse Pointer button, Timer button, Keystone button

Basic Operation

FILTER button Remote Control Unit

Press and hold the FILTER button for more than 5 seconds to operate electrically operated filter to replace the filter.

Note:

•When the filter is replaced, the total accumulated time of the filter use is automatically set to 0.

BLANK button

Press the BLANK button on the remote control unit to black out the image. To restore to normal, press the BLANK button again or press any other button.

P-TIMER button

“Blank” disappears after 4 seconds.	FILTER
	button

MOUSE POINTER button

POINTER button

KEYSTONE button

BLANK button

MOUSE POINTER button

Move the pointer on the screen with this button.

POINTER button

Press POINTER button on the remote control unit to display the Pointer on the screen.

Note:

•See the previous page for the description of other buttons.

P-TIMER button

Press the P-TIMER button on the remote control unit. The Timer display “00 : 00” appears on the screen and starts to count time (00 : 00–59 : 59).

To stop the P-TIMER, press the P-TIMER button.

To cancel the P-TIMER, press the P-TIMER button again.

KEYSTONE button

Press the KEYSTONE button on the remote control unit. The “Keystone” appears on the screen.

Use the Point !  buttons to correct keystone distortion. The keystone adjustment can be stored (pp.40, 44).

P-Timer display

•The white arrows indicate that there is no correction.

•A red arrow indicates the direction of correction.

•An arrow disappears at the maximum correction.

•If you press the KEYSTONE button on the remote control unit again while the Keystone dialog box is being displayed, the keystone adjustment will be canceled.

•“Keystone” disappears after 10 seconds.

Reduce the upper width with	Reduce the	lower width	Reduce the left part with
Point ! button.	with Point	button.	Point  button.

Reduce the right part with Point button.

29