Canon 7585 manual Remote control unit, Does not work, Wireless mouse, Function does not, Work

Appendix

Problem:	Try These Solutions
Remote control unit	L Check the batteries.
does not work.	LL Check if the ALL-OFF switch on the remote control unit is set to “ON.”
	L Check if the RC sensor is set properly. (See page 51)
	L Make sure no obstruction is between the projector and the remote control unit.
	L Make sure you are not too far from the projector when using the remote control unit.
	Maximum operating range is 16.4’ (5 m).
	L Make sure that the remote control code conforms to the projector’s code.
	(See page 51.)
	L Unlock the Key lock function for the remote control unit. (See page 53).
	L Wireless remote control unit does not work when the remote control cable is connected
	to the projector. (See page 15).
Wireless mouse	L Check the cable connection between the projector and your computer.
function does not	L Check the mouse setting on your computer.
work.	L Turn on the projector before you turn on the computer.
Unable to unlock the	L Contact the service station.
Logo PIN code lock,
Security key lock or
Security PIN code
lock.
	L Your operation is invalid. Operate correctly.
appears on the
screen

WARNING:

High voltages are used to operate this projector. Do not attempt to open the cabinet.

If problems still persist after following all operating instructions, contact the dealer where you purchased the projector or the service center. Specify the model number and explain about the problem. We will advise you how to obtain service.

65