Canon 7585 manual Compliance, Federal Communications Commission Notice

Page 9

Compliance

Federal Communications Commission Notice

Multimedia Projector, Model: LV-7585

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)This device may not cause harmful interference, and

(2)this device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Use of shielded cable is required to comply with class B limits in Subpart B of Part of FCC Rules.

Do not make any changes or modifications to the equipment unless otherwise specified in the instructions. If such changes or modifications should be made, you could be required to stop operation of the equipment.

Canon U.S.A., Inc.

One Canon Plaza, Lake Success, NY 11042-1198, U.S.A.

Tel No. (516)328-5000

Canadian Radio Interference Regulations

This Class B digital apparatus complies with Canadian ICES-003.

AC POWER CORD REQUIREMENT

The AC Power Cord supplied with this projector meets the requirement for use in the country you purchased it.

AC Power Cord for the United States and Canada:

AC Power Cord used in the United States and Canada is listed by the Underwriters Laboratories

 

(UL) and certified by the Canadian Standard Association (CSA).

 

AC Power Cord has a grounding-type AC line plug. This is a safety feature to be sure that the

 

plug will fit into the power outlet. Do not try to defeat this safety feature. Should you be unable

GROUND

to insert the plug into the outlet, contact your electrician.

 

THE SOCKET-OUTLET SHOULD BE INSTALLED NEAR THE EQUIPMENT AND EASILY ACCESSIBLE.

European Union (and EEA) only.

This symbol indicates that this product is not to be disposed of with your household waste, according to the WEEE Directive (2002/96/EC) and your national law. This product should be handed over to a designated collection point, e.g., on an authorized one-for-one basis when you buy a new similar product or to an authorized collection site for recycling waste electrical and electronic equipment (EEE). Improper handling of this type of waste could have a possible negative impact on the environment and human health due to potentially hazardous substances that are generally associated with EEE. At the same time, your cooperation in the correct disposal of this product will contribute to the effective usage of natural resources. For more information about where you can drop off your waste equipment for recycling, please contact your local city office, waste authority, approved WEEE scheme or your household waste disposal service. Your cooperation in the correct disposal of this product will contribute to the effective usage of natural resources and will avoid incurring administrative sanctions according to art. 50 and following of Italian legislative decree 22/97. For more information regarding return and recycling of WEEE products, please visit www. canon-europe.com/environment.

(EEA: Norway, Iceland and Liechtenstein)

9

Image 9
Contents 8VHU·V0DQXDO Features and Design Table of Contents Risk of Electric Shock Do not Open To The OwnerSafety Instructions Top Panel Air CirculationPositioning Precautions Installing the Projector in Proper DirectionsTransporting the Projector Moving the ProjectorCompliance AC Power Cord for the United States and CanadaFederal Communications Commission Notice Canadian Radio Interference RegulationsFront Back Part Names and FunctionsBottom  Top Cover Release Button Lens CapReset button USB Connector Series BRear Terminal INFRARED Remote Receiver BackIndicators on the top panel Side Control and IndicatorsRemote Control Unit FOCUS buttons Adjust the focus p.28 BLANK button P-TIMER buttonMENU button D-ZOOM buttonRemote Control Battery Installation Remote Control Receivers and Operating RangeWired Remote Control Transmitter Remote Control Code Installation Adjustable FeetPositioning the Projector Removing the lens Lens InstallationAttaching the lens to the projector DVI-Digital Cable = USB Cable BNC Cable = Connecting to a Computer Digital and Analog RGBMonitor Out Signal Table Connecting to Video Equipment Video, S-VideoConnecting the AC Power Cord For the U.KFor the U.S.A. and Canada For Continental Europe Basic Operation What is PIN code?Turning On the Projector Enter a PIN codeTurning Off the Projector Remote Control Unit How to Operate the On-Screen MenuSide Control On-Screen MenuMenu Bar Focus Adjustment Zoom AdjustmentLens Shift Adjustment Operating with Projector ControlOperating with Remote Control Unit Filter button Timer buttonBlank button Mouse Pointer buttonWireless Mouse Operation Pointer FunctionPointer Remote Control button operation Remote Control OperationInput Selection InputMenu Operation Computer Input Source SelectionInput Menu Source Select MenuVideo Input Source Selection When Selecting Input 3 AV TerminalsComputer System Selection Computer InputAutomatic Multi-Scan System Selecting Computer System ManuallyPC Adjust Menu Auto PC AdjustmentDirect Operation Auto PC adjManual PC Adjustment Mode free To clear the adjusted data ResetTo store the adjusted data StoreStandard Image Level SelectionHigh contrast CustomScreen Menu Screen Size AdjustmentCeiling KeystoneRear Digital zoom +Video System Selection Video InputVideo Jack or S-Video Jack Pb/Cb, Pr/Cr JacksCinema Provide the image at the normal video aspect ratio Keystone Image Adjust Menu Image AdjustmentPointer Mode Picture ImageMenu Color MList Color M Menu Color PaletteOffset Red/Green/Blue White balance Red/Green/BlueSharpness GammaSetting SettingLogo Logo selectLogo Capture Change the Logo PIN code lock setting Enter a Logo PIN codeChange the Logo PIN code RC sensor USB Security Key lock PIN code lockSecurity Change the PIN Code Change the PIN Code Lock settingFactory default Filter counterTest pattern Filter Instructions Maintenance and CareReplacing the Filter Cartridge Reset the filter counter and the scroll counter p.58Resetting the Scroll Counter Resetting the Filter CounterFilter counter Scroll counterLamp Replace indicator Lamp ReplacementReset the Lamp counter p.60 Top PanelOrder Replacement Lamp Resetting the Lamp CounterLamp Handling Precautions Cleaning the Projector Cabinet Cleaning the Projection LensThen check the matters below Lamp indicator lights on and other four indicators blinkAppendix TroubleshootingWireless mouse Remote control unitDoes not work Function does notMenu Tree Image AdjustComputer Input/Video Input InformationSystem PC AdjustImage Select ScreenUSB SettingIndicators and Projector Condition Projector is operating normallyProjector is detecting abnormal condition Appendix Indicators Resolution Compatible Computer Specifications59.940 Signal Compatibility Panel ResolutionPower AccessoriesTo the sales and service engineers Lens ReplacementOptional Parts PJ Link NoticeUSB Connector Series B Configurations of TerminalsControl Port Connector D-sub 9 pin ANALOG/ Monitor OUT Mini D-sub 15 pinWhile the projector is locked with the PIN code Dimensions Serial Control Interface OperationExample Format Functional Execution CommandCR0 Status Read CommandCanon Italia S.p.A Canon Deutschland GmbHCanon Schweiz A.G Canon GmbH