Ethernet Configuration

Crestron CEN-CN

Ethernet/Cresnet Interface

5.As a result of the update, a dialog box (similar to as shown below) may open and the SIMPL program (and possibly SIMPL+ modules) must be cleared. As shown below, click the Yes button.

Continue with transfer? Selection Box

6.Upload the SIMPL program and SIMPL+ modules after the transfer is complete.

This section explains how to configure a CEN-CN to communicate over Ethernet using the TCP/IP. Connection to a LAN/WAN via a hub is not required for these procedures.

NOTE: For configuration of the host control system, refer to the latest revision of the appropriate Operations Guide and the “IP Table Setup” section of the Operations

&Installation guide for the CNXENET+ (Doc. 8153). The latest version can be obtained from the Downloads page (MANUAL Library) of Crestron’s website (www.crestron.com). New users are required to register in order to obtain access to the FTP site. If the host control system uses the standard CNXENET card, contact Crestron customer service for further information.

Initial IP Setup

NOTE: This initial IP setup MUST be done via the PC port of the CEN-CN. Before performing the procedures in this section, refer to “Obtaining Communications” on page 7 for cabling instructions. Thereafter, communications may be achieved by using the Crestron Viewport to connect directly to the IP address assigned to the CEN-CN.

1.From the Crestron Viewport, select Functions Set Control System IP Information, as shown on the next page.

Operations Guide - DOC. 5721

Ethernet/Cresnet Interface: CEN-CN ∙ 13