Crestron electronic CEN-CN manual Communications, Communicating via Ethernet

Ethernet/Cresnet Interface	Crestron CEN-CN
Typical Connections for Normal Operation

TO CRESNET DEVICE OR SMARTOUCH MODULE

TO CRESNET

DEVICES

12VDC

.5A

P C	N E T
	N E T
	2 4 Y	Z G

N E T

2 4 Y Z G

ETHERNET

CRESTRON ELECTRONICS INC. ROCKLEIGH, N.J. 07647 USA

FROM EXTERNAL AC POWER PACK

(OPTIONAL. OPERATING POWER MAY BE SUPPLIED VIA CRESNET WIRING)

TO LAN/WAN

VIA HUB

Communications

Communicating via Ethernet

NOTE: Before performing this procedure, refer to “Hookup Diagram for Normal

Operation” on page 17 for cabling instructions.

The Crestron Viewport may be used to communicate with the CEN-CN via Ethernet. This is useful for changing the IP Table or updating the UPZ. The CEN-CN needs to be configured via the serial port for the first time (IP Address, etc). Refer to “Initial IP Setup” on page 13. To connect the Viewport to the unit, perform the following procedure.

1.In the Viewport, select Remote TCP/IP Connect as shown below.

Viewport Connect TCP/IP Function

18 ∙ Ethernet/Cresnet Interface: CEN-CN Operations Guide - DOC. 5721