Crestron electronic CEN-CN manual IP Table Setup, Changing the IP Table via Crestron Viewport

Ethernet/Cresnet Interface	Crestron CEN-CN
Reboot Dialog Box

6.Observe a confirmation message that the IP information has been setup. After the system reboots, select Function Cold Boot, to view the IP Information.

NOTE: If an error that the viewport could not setup the IP information opens, contact Crestron customer service for assistance.

IP Table Setup

The CEN-CN may have the IP Table set through Crestron Viewport via direct connection to the PC port or connected via TCP/IP once the IP Address of the CEN-CN has been set. Just as each Cresnet device is assigned a Cresnet NET ID, e.g. 03 through FE, to be used when programming, a CEN-CN is assigned an IP ID which also may range from 03 through FE.

NOTE: Make sure that in the “Add IP Entry Table Dialog Box”, the “Set as Master” checkbox is selected as shown below to specify the IP address of the system to be designated as the host control system.

Add IP Entry Dialog Box

NOTE: The CEN-CN has a limit of one entry that may be entered into the IP table. Although the entry may be placed anywhere in the table (position 03 to FE), attempting to place more than one (1) non-zero entries in the table will result in an error message.

Changing the IP Table via Crestron Viewport

You can modify the corresponding IP address for any IP ID by changing the IP table directly. From the Crestron Viewport, first establish communications with the CEN- CN, then select Functions Setup IP Table then click the Retrieve Current IP Table from Control System button. This will extract the IP table from the CEN-CN

16 ∙ Ethernet/Cresnet Interface: CEN-CN Operations Guide - DOC. 5721