BOXLIGHT MP-57i, MP-58i user manual Option Menu

Multifunctional Settings (continued)

OPTION Menu

With the OPTION menu, the items shown in the table below can be performed. Perform each operation in accordance with the instructions in the table below.

MENU
MAIN	VOLUME	16
PICTURE-1	SPEAKER	TURN ON
PICTURE-2	IR REMOTE
INPUT	IR REMOTE ID	ALL
AUTO	LAMP TIME	1234 h
SCREEN	FILTER TIME	4321 h
OPTION	SERVICE
NETWORK	RESET
: SELECT

Item				Description
VOLUME	Adjust the volume using the			/	buttons. :
	High	Low
	Select the TURN ON or the TURN OFF using the						/	buttons. :
SPEAKER	TURN ON		TURN OFF
	When the TURN ON is selected, the built-in speaker works.
	Select a remote sensor using the				/	button (1), then switch
										OPTION
	it using the ENTER button (2). :									IR REMOTE
										FRONT
IR REMOTE	(1) FRONT		TOP REAR (2)			(Off)	(On)
										TOP
	memo A sensor cannot be turned off when the other two are off.									REAR
										ENT
	Always at least one sensor is on.
	Select a number as an ID number for remote control using the								/	buttons. :
	ALL	1	2 3
	The projector is controlled by the remote control whose ID CHANGE switch is
IR REMOTE ID	set into the position of the same number as this number. When the ALL is
	selected, the projector is controlled by a remote control irrespective of the
	position of the ID CHANGE switch.
	memo Please refer to the section “Using The Remote ID Feature”.
	Pressing the RESET button for about 3 seconds displays the LAMP TIME menu.
	Select the RESET using			button to reset the timer. :
	RESET	CANCEL
LAMP TIME	Selecting the RESET resets the count of the lamp timer to 0.
	memo Perform this function only when you have replaced the lamp. The lamp
	timer counts the used time of the current lamp, to display the messages about
	the lamp. Incorrect performing causes incorrect operation of the messages.
	memo About replacing the lamp, please refer to the section” Lamp”.
	Pressing the RESET button for about 3 seconds displays the FILTER TIME
	menu.
	Select the RESET using			button to reset the timer. :
	RESET	CANCEL
FILTER TIME	Selecting the RESET resets the count of the lamp timer to 0.
	memo Perform this function only when you have cleaned or replaced the air
	filter. The filter timer counts the used time of the air filter after cleaning or
	replacement, to display the messages about the air filter. Incorrect performing
	causes incorrect operation of the messages.
	memo About caring for the air filter, please refer to the section “Air Filter”.
				(This table is continued to the following page.)

33