BOXLIGHT MP-58i, MP-57i user manual Replacing The Lamp, Dealer to replace the lamp, Knob

Lamp (continued)

Replacing The Lamp

If the indicators or a message prompts you to replace the lamp, replace the lamp as soon as possible.

1	Turn off the projector, and unplug the power cord. Allow the lamp bulb to cool for at
	least 45 minutes.
	Contact your dealer to prepare a new lamp. Tell the dealer your lamp type number.
2
	If the projector is mounted on the ceiling, or if the lamp has broken, also ask the

dealer to replace the lamp.

In the case of replacement by yourself,

After making sure that the projector has cooled

3 adequately, slide the knob of a lamp cover lock as shown in the Figure. Then, one side of the lamp cover is raised. Pull up the lamp cover and remove it, as shown in the Figure.

Lamp cover	Lamp cover
knob

Unscrew the 3 screws, and slowly pull out the lamp

4 by the handle. Be careful not to touch the inside of Screws the lamp case.

5	Insert the new lamp, and tighten the 3 screws firmly
	to lock it in place.

PC

CO LAMP

6	Interlocking the 2 tabs of the lamp cover to the
	projector, put the lamp cover on the projector. Then				Tabs
	push the point of the lamp cover to fix it, as shown in
	the Figure. Make sure that the lamp cover does’t
	come up.
7	Turn on the projector, and reset the lamp timer.
	(1)	While the projector running, press the MENU button to open the menu.
	(2)	Choose the “OPTION” on the menu using the		/	button, then press the
		button or ENTER button.
	(3)	Choose the “LAMP TIME” using the	/	button, then press and hold the
		RESET button for 3 seconds.
	(4)	Choose the “RESET” using the button.

memo When the lamp has been replaced after the message of "THE POWER WILL TURN OFF AFTER 0hr." is displayed, complete the following operation within 10 minutes of switching power on.

memo Incorrectly resetting of the lamp timer (resetting without replacement, or neglect of resetting after replacement) will result in incorrect message functions.

38