Troubleshooting (continued)
Phenomena That May Easily Be Mistaken For Machine Defects
WARNING • Never use the projector if abnormal operations such as smoke, strange odor, excessive sound, damaged casing or elements or cables,
penetration of liquids or foreign matter, etc. should occur. In such cases, immediately turn off the power switch and then disconnect the power plug from the power outlet After making sure that the smoke or odor has stopped, contact your dealer or service company.
Before requesting repair, please check in accordance with the following chart. If the situation cannot be corrected, please contact your dealer or service company.
NOTE • Although bright spots or dark spots may appear on the screen, this is a unique characteristic of liquid crystal displays, and such do not constitute or imply a machine defect.
Phenomenon | Cases not involving a machine defect | Reference | |
pages | |||
|
| ||
|
|
| |
| The electrical power cord is not plugged in. | 11 | |
| Correctly connect the power cord. | ||
|
| ||
|
|
| |
| The power switch is not set to the on position. | 15 | |
| Set the power switch to [ ] (On). | ||
|
| ||
|
|
| |
| The main power source has been interrupted during operation |
| |
| such as by a power outage (blackout), etc. | 15 | |
Power does not | Please turn the power off, and allow the unit to cool down at least 20 | ||
come on. | minutes. After the projector has sufficiently cooled down, please turn |
| |
| the power on again. |
| |
|
|
| |
| Either there is no lamp and/or lamp cover, or either of these has |
| |
| not been properly fixed. |
| |
| Please turn the power off, and allow the unit to cool down at least 45 | 35, 36 | |
| minutes. After the projector has sufficiently cooled down, please | ||
|
| ||
| make confirmation of the attachment state of the lamp and lamp |
| |
| cover, and then turn the power on again. |
| |
|
|
| |
| The signal cables are not correctly connected. | 8, 9 | |
| Correctly connect the connection cables. | ||
|
| ||
|
|
| |
Neither sounds | Signal source does not correctly work. | - | |
nor pictures are | Correctly set up the signal source device by referring to the manual | ||
outputted. | of the source device. |
| |
|
|
| |
| The input changeover settings are mismatched. | 16 | |
| Select the input signal, and correct the settings. | ||
|
| ||
|
|
| |
| (This table is continued to the following page.) | ||
45