Connecting the Speakers
Read the following before connecting your speakers:
•Turn off your receiver or amp before making any con- nections.
•Pay close attention to speaker wir-
ing polarity. Connect positive (+) terminals to only positive (+) ter- minals, and negative
•Be careful not to short the positive and negative wires. Doing so may damage your amp.
Connecting the Speaker Cables
1 | Use the supplied cables to connect each | ||
| speaker’s input terminals to the corre- | ||
| sponding speaker output terminals on | ||
| your receiver or amp. |
|
|
| Match the color of each cable to the correspond- | ||
| ing speaker terminal. |
|
|
| To make a connection, while |
| |
| pressing the terminal lever, |
| |
| insert the wire into the hole, and |
| |
| then release the lever. |
|
|
| Make sure that the terminals are |
| |
| gripping the bare wires, not the insulation. | ||
Connecting the Subwoofer |
| ||
1 | Using the supplied RCA cable, connect | ||
| the subwoofer’s LINE INPUT to your AV | ||
| receiver’s SUBWOOFER PRE OUT. | ||
| |||
|
| Green |
|
| Red |
|
|
|
|
| White |
PRE OUT
SUB
WOOFER
Blue
Brown Gray
Tan
Power Cord Precautions
•Before connecting the power cord, connect all of your speakers and AV components.
•Turning on the
Adjustment
Setting the Subwoofer Level
To set the level of the subwoofer, use the OUTPUT LEVEL control. Set it so that bass sounds are evenly bal- anced with the treble sounds from the other speakers. Because our ears are less sensitive to very low bass sounds, there’s a temptation to set the level of the sub- woofer too high. As a rule of thumb, set the subwoofer level to what you think is the optimal level, and then back it off slightly.
MIN MAX
OUTPUT LEVEL