BenQ CP120 Do not block the ventilation holes, Bedding or any other soft surface, Other item

Page 11

Safety instructions (continued)

7.	Do not place this projector in any of the 8.	Do not block the ventilation holes.
	following environments.	- Do not place this unit on a blanket,
	- Space that is poorly ventilated or confined.	bedding or any other soft surface.
	- Space that is poorly ventilated or confined.	- Do not cover this unit with a cloth or any
	Allow at least 50 cm clearance from walls	- Do not cover this unit with a cloth or any
	and free flow of air around the projector.	other item.
	- Locations where temperatures may	- Do not place inflammables near the
	become excessively high, such as the	projector.
	inside of a car with all windows rolled up.
	inside of a car with all windows rolled up.
	- Locations where excessive humidity, dust,
	or cigarette smoke may contaminate
	optical components, shortening the
	projector’s life span and darkening the
	image.

- Locations near fire alarms

- Locations with an ambient temperature above 40°C / 104°F

- Locations where the altitudes are higher than 10000 feet.

If the ventilation holes are seriously obstructed, overheating inside the unit may result in a fire.

9. Always place the unit on a level, horizontal surface during operation.

- Do not use if tilted at an angle of more than 10 degrees left to right, nor at angle of more than 15 degrees front to back. Using the unit when it is not fully horizontal may cause a malfunction of, or damage to, the lamp.

10. Do not step on the projector or place any objects upon it.

- Besides probable physical damage to the projector, doing so may result in accidents and possible injury.

Important safety instructions

3

Image 11

Contents Welcome Software license agreement CopyrightDisclaimer Copyright Memo Table of Contents Iv Table of Contents Fine-tuning the image size and clarityTable of Contents Dimensions Timing chartMemo Vi Table of Contents Important safety instructions Important safety instructionsBut could fail if power cuts or surges Safety instructions Other item Do not block the ventilation holesFollowing environments Do not place this unit on a blanket Bedding or any other soft surfaceSafety instructions Introduction Projector featuresIntroduction Shipping contents Lower side Projector exterior viewFront / Upper side Rear sideTurns the projector on or off Introduction Controls and functionsExternal control panel Adjusts the focus of the projected image Turns the projector on or off Remote control descriptionDown on the remote control Press this button to display the Wireless Connection menuInstalling or replacing the remote control battery Remote control effective rangeEquipment Positioning your projectorChoosing a location Obtaining a preferred projected image sizeSelect your screen size Positioning your projector Screen Center of lens Projection distance Screen size chartMaximum Minimum Zoom Connection Connecting a computerConnection Best video quality Connecting Video source devicesComponent Video to VGA D-Sub adaptor cable Device Connecting a Component Video source deviceVideo cable Device Connecting an S-Video source deviceConnecting a composite Video source device Start up Using the projectorSwitch all of the connected equipment on Using the projectorTo set a password Utilizing the password functionTo change the password If you forget the passwordTo enter the password recall procedure That you need using the zoom ring Focus ring Adjusting the heightAuto-adjusting the image Fine-tuning the image size and clarityRight buttons on Correcting keystoneManual keystone correction Automatic keystone correction Selecting an application modeSwitching input signal Hiding the imageShutdown Disconnect the power cord from the wall socketRemote paging operations Freezing the imageHardware and software requirements Using the wireless functionsAbout wireless connection modes and channels Checking the TCP/IP settings of your computer Preparing your computer for wireless connectionInstalling Wireless Wizard Making wireless presentationClick to select a wireless network card from the list Current wireless connection channel Page Freezing image Controlling presentationMethod 2 Projector control DisconnectingMenu system Menu operationUsing the menus Picture menu Depends on Selected Application ModeKeystone Color TempPro-Picture menu Setting menu Advance menu Periods of time 10hours without shutdown Turned off. Selecting Off disables this functionAuto Off Off EconomicSource ResolutionMode Equivalent Information MenuCare of the projector MaintenanceMessage Status Calculation of lamp hourReplacing the lamp Resetting the lamp counter Temperature informationPowering up IndicatorsProjector needs to cool after the power is Turned off Stand-by modeMaintenance Image is unstable TroubleshootingProjector does not turn on No pictureNearby Remote control does not workUnable to use wireless connection ConfiguredProjector specifications SpecificationsSupported timing for PC input DimensionsTiming chart Horizontal Vertical Pixel Resolution Frequency Mode KHz MHzSupported timing for Video and S-Video inputs Signal Format Horizontal Frequency Vertical Frequency KHzSupported timing for Component-YPbPrInput Warranty WarrantyLimited warranty MIC statement Regulation statementsFCC statement EEC statementMemo Regulation statements