BenQ PB9200 user manual PICTURE-2 Menu, Position, Phase, Size, Over Scan

PB9200-e.book Page 25 Thursday, May 27, 2004 2:15 PM

PICTURE-2 Menu

With the PICTURE-2 menu, the items shown in the table below can be performed. Perform each operation in accor- dance with the instructions in the table below.

memo This menu cannot be selected at a M1-D signal.

MENU

MAIN	V POSITION	20
PICTURE-1	H POSITION	142
PICTURE-2	H PHASE	31
INPUT	H SIZE	1344
AUTO	OVER SCAN	95
SCREEN	RESET
OPTION
NETWORK
: SELECT

Item Description

Adjust the vertical position using the 5 / 6 buttons. :

V POSITION Up Down

memo This item can be selected only at a RGB signal.

Adjust the horizontal position using the 5 / 6 buttons. :

H POSITION Left Right

memo This item can be selected only at a RGB signal.

Adjust the horizontal phase to eliminate flicker using the 5 / 6 but- tons. :

H PHASE	Right	Left
	memo This item can be selected only at a RGB signal or a compo-
	nent video signal other than a COMPONENT port input of 525i/
	625i/SCART RGB.

Adjust the horizontal size using the 5 / 6 buttons. :

	Large	Small
H SIZE	memo This	item can be selected only at a RGB signal.
	memo When this adjustment is excessive, the picture may not be dis-
	played correctly. In such a case, please reset the adjustment pressing
	the RESET button during this operation.

Adjust the over-scan ratio using the 5 / 6 buttons. :

	Small	Large
OVER SCAN	memo This	item can be selected only at a video signal.
	memo When this adjustment is too large, certain degradation may
	appear at the frame area of the picture. In such a case, please adjust
	small.

Select the EXECUTE using the 5 button to reset the PICTURE-2 menu items. :

RESET EXECUTE CANCEL

The items of the PICTURE-2 menu are collectively returned to the initial setting. Note that the item H PHASE is not reset.

Multifunctional Settings 25