Onkyo HT-RC360 Displaying Source Information, Changing the Input Display, Vcr/Dvr

Displaying Source Information

You can display various information about the current input source as follows. (Components connected to the UNIVERSAL PORT jack are excluded.)

1 Press RECEIVER followed by DISPLAY repeatedly to cycle through the available information.

The following information can typically be displayed.

Input source

Listening mode

Signal format*1

Sampling frequency

Input signal resolution

Output resolution

Tip

• Alternatively, you can use the AV receiver’s DISPLAY.

*1 If the input signal is analog, “Analog” is displayed. If the input signal is PCM, the sampling frequency is displayed. If the input signal is digital but not PCM, the signal format is displayed. Information is displayed for about three seconds, then the previously displayed information reappears.

Changing the Input Display

When you connect an u-capable Onkyo component, you must configure the input display so that ucan work properly.

This setting can be done only from the front panel.

1 Press TV/CD, GAME or VCR/DVR.

“TV/CD”, “GAME” or “VCR/DVR” appears on the display.

2 Press and hold down TV/CD, GAME or VCR/DVR

(about 3 seconds) to change the input display.

Repeat this step to select the desired input display. ■ TV/CD:

TV/CD → DOCK

→
	TAPE
	→
■ GAME:

GAME ↔ DOCK

■VCR/DVR:

VCR/DVR ↔ DOCK

Note

•DOCK can be selected for the TV/CD, GAME or VCR/DVR input selector, but not at the same time.

•Enter the appropriate remote control code before using the remote controller for the first time (➔ page 62).

Using the Music Optimizer

The Music Optimizer function enhances the sound quality of compressed music files.

1 (North American models) Press MUSIC OPTIMIZER on the front panel.

The M.Opt indicator lights on the display.

The MUSIC OPTIMIZER indicator lights on the front panel.

Tip

•Alternatively, you can use the remote controller’s HOME and arrow buttons.

•See “Music Optimizer” for more details (➔ page 56).

En

38