Onkyo HT-RC360 Remote Control Codes for Onkyo Components Connected via u, Controlling a TV

Remote Control Codes for Onkyo Components Connected via u

Onkyo components that are connected via uare controlled by pointing the remote controller at the AV receiver, not the component. This allows you to control components that are out of view, in a rack, for example.

1 Make sure the Onkyo component is connected with an ucable and an analog audio cable (RCA).

See “Connecting Onkyo uComponents” for details

(➔ page 18).

2 Enter the appropriate remote control code for REMOTE MODE, referring to the previous section.

`42157:

Onkyo cassette tape deck with u

`81993:

Onkyo Dock with u

3 Press REMOTE MODE, point the remote controller at the AV receiver, and operate the component.

Controlling Onkyo components without u

If you want to control an Onkyo component by pointing the remote controller directly at it, or you want to control an Onkyo component that’s not connected via u, use the following remote control codes:

`30627:

Onkyo DVD player without u

`71817:

Onkyo CD player without u

`32900/33100/33500: Onkyo Blu-ray Disc player

`32901/33104/33504: Onkyo HD DVD player

`70868:

Onkyo MD recorder without u

`71323:

Onkyo CD recorder without u

`82990:

Onkyo Dock without u

Resetting REMOTE MODE Buttons

You can reset a REMOTE MODE to its default remote control code.

1	While holding down REMOTE MODE that you
	want to reset, press and hold down HOME until the
	remote indicator lights (about 3 seconds).
2	Within 30 seconds, press REMOTE MODE again.

The remote indicator flashes twice, indicating that the button has been reset.

Each of REMOTE MODE is preprogrammed with a remote control code. When a button is reset, its preprogrammed code is restored.

Resetting the Remote Controller

You can reset the remote controller to its default settings.

1	While holding down RECEIVER, press and hold
	down HOME until the remote indicator lights
	(about 3 seconds).
2	Within 30 seconds, press RECEIVER again.
	The remote indicator flashes twice, indicating that the

remote controller has been reset.

Controlling Other Components

By pressing the REMOTE MODE that’s been programmed with the remote control code for your component, you can control your component as described below.

For details on entering a remote control code for other components, see “Entering Remote Control Codes” (➔ page 62).

Controlling a TV

TV is preprogrammed with the remote control code for controlling a TV that supports the p*1 (limited to some models). The TV must be able to receive remote control commands via pand be connected to the AV receiver via HDMI. If controlling your TV via

pdoesn’t work very well, program your TV’s remote control code into TV and use the TV remote mode to control your TV.

Use the following remote control codes:

`11807/13100/13500: TV with p

Controlling a Blu-ray Disc/DVD Player, HD DVD Player or DVD Recorder

BD/DVD is preprogrammed with the remote control code for controlling a component that supports the p*1 (limited to some models). The component must be able to receive remote control commands via pand be connected to the AV receiver via HDMI.

Use the following remote control codes:

`32910/33101/33501/31612:

Blu-ray Disc/DVD player with p

*1 The psupported by the AV receiver is the CEC system control function of the HDMI standard.

En

63