Home Automation 1503 owner manual

When the last call is made in the MEDICAL DIAL ORDER, the house phones are reconnected and the system stops dialing.

-The console beeper continues to sound and the lights continue to flash until the alarm is turned off.

At any time, the alarm system can be turned off by the console. Medical alarms can also be turned off by pressing the CANCEL key.

DURESS CODE ENTERED or DURESS ALARM ACTIVATED

(See DURESS CODE for a descrip- tion of when to use the DURESS CODE.)

In the event that you enter your duress code, or a zone configured as a duress zone is tripped, the system performs a silent dial out as follows:

-No alarms, lights or console beepers are activated. The sys- tem does not display the duress alarm.

-The system waits the dial out delay, then begins to dial out.

If you are having your system monitored by a central station, the central station will be sent a code representing the type of alarm (duress.)

If you are not using central station monitoring but are using the voice dial out capability, the

Model 1503 Owner's Manual

system looks at the BURGLAR DIAL ORDER to determine which number to call first, and calls that number.

If you are using both central station monitoring and voice dial out, then the voice dial out is delayed by five minutes to give the central station time to call you back.

For the voice dialer, the system dials the first number in the BUR- GLAR DIAL ORDER and delivers the message: “EMERGENCY... EMERGENCY...

THE BURGLAR ALARM HAS BEEN ACTI- VATED AT THE FOLLOWING ADDRESS: (Your address is spoken here*)

PHONE NUMBER (your phone number that is stored in SET-UP location MY PHONE NUMBER is spoken here)

THIS IS A SILENT ALARM. PLEASE RESPOND IMMEDIATELY.”

*NOTE: Model 1503-LC systems do not speak the address, only the phone number.

ALARM RESET

The alarm system will reset it- self after the outside siren has been on for 4 minutes. When the alarm system resets, any zone that is not in alarm is reactivated, so the alarm system will be activated again if the zone is tripped. If a zone has been left in alarm, i.e. a door has been left open, it will be automatically bypassed when the alarm resets.

The console display will indi- cate “(FIRE, BURGLAR or EMERGENCY) ALARM RESET” when this happens. The FLASH FOR ALARM lights will con-

19