Home Automation 1503 owner manual Home Automation, For example, 1, 0, #

Home Automation,

control, then press the # key.

For example, 1, 0, #.

The Model 1503 will say “UNIT NUMBER 10. COMMANDS ARE: 0: OFF, 1: ON, 2: OFF FOR TIME, 3: ON FOR TIME, 4: LO, 5: HI, STAR (*): CAN- CEL.”

(If you enter a number that is not a valid unit number then you will hear three beeps and the Model 1503 will re-read the instructions

“ENTER UNIT NUMBER THEN POUND KEY”. If you wish to cancel, press *.)

ON, OFF, TIMED ON AND TIMED OFF COMMANDS

Press 0 to turn unit 10 off, 1 to turn it on or the * key to cancel.

The Model 1503 will say ON, OFF or CANCEL depending on what you press. The Model 1503 will beep once, indicating that it has done what you asked, then go back to the

MAIN MENU.

Pressing 2 (OFF FOR TIME) or 3 (ON FOR TIME) will evoke the re- sponse “ENTER TIME, THEN POUND KEY”. Enter the time in minutes for the OFF FOR or ON FOR command, then the # key.

The system will confirm your selection by saying “ON FOR (or OFF FOR) (number of minutes you en- tered)”, then beep once. You can cancel by pressing the * key.

Pressing 4 (LO) or 5 (HI) will evoke different responses depending on the unit number.

DIMMING AND BRIGHTENING

For unit numbers 1 - 16 (and 81

-128 on Version 2 systems) LO and HI refer to dimming and brighten- ing.

After entering the unit number and pressing the # key, press 4 to dim or 5 to brighten the lamp.

The Model 1503 will lower the light level one step for each pressing of the 4 key, and raise the light level one step for each pressing of the 5 key.

When you are finished, press the * key. You will return to the main menu.

For example, to dim unit number 5 two steps, press 1, 5, #, 4, 4.

Unit numbers 17 and 19 (and 20 -

80 on expanded Version 2 systems) are either relay outputs or Model 1101 Programmable Energy Saver Relays, and cannot be dimmed or brightened.

MODEL 1101 PROGRAMMABLE ENERGY SAVER RELAYS (PESM)

If you have one or more Program- mable Energy Saver Modules in- stalled, you can hear the tempera- ture, turn it on or off and change the high and low temperatures over the phone.

To read the temperature of a PESM, press 1 for home control, then enter the unit number and the pound (#) key.

The Model 1503 will say “UNIT NUMBER xx ENERGY SAVER IS (ON or

OFF): TEMPERATURE IS 76 DEGREES.

54