Home Automation 1503 The programmed ENTRY DELAY is, seconds the programmed, EXIT DELAY is seconds

If you do enter through an EN- TRY-EXIT zone first, then the other zones are disabled during the ENTRY DELAY, in case you have to cross through another zone to get to your console (an interior motion detec- tor, for example.)

To put your system in the AWAY mode,

Press the AWAY key.

Press your code number on the keypad.

The console will beep once and the red indicator on the AWAY key will light. Leave your home and close the door promptly. The system will be fully armed after the EXIT DELAY. If you make a mistake, press CANCEL and start over.

The programmed ENTRY DELAY is

__________ seconds; the programmed

EXIT DELAY is __________ seconds.

QUICK ARM

For extra convenience, the Model 1503 can be armed simply by press- ing the HOME, ASLEEP or AWAY button twice, eliminating the need to enter the code.

To quick arm the system in the AWAY mode, press AWAY, AWAY.

The quick arm feature only works if the alarm system is in the OFF mode, and if no alarms are sound- ing. This feature is disabled when the system is shipped from the factory. If desired, it can be enabled or disabled at any time. See SET-UP, MISC., QUICK ARM.

Model 1503 Owner's Manual

BYPASSING ZONES

You can BYPASS a zone that you do not want protected while the system is armed. Only the MASTER CODE can bypass and restore zones.

Bypassing is also the only way that a tamper or panic zone can be disarmed. For example, if there is a liquor closet or gun case on a tamper zone, then you must bypass that zone to gain access to it.

Another reason to BYPASS a zone is if the zone is having trouble. If a zone is causing a trouble indication, you can bypass that zone to “cut it out” of the system until repairs are made.

When a zone is bypassed, it is no longer checked for alarm or trouble conditions. When you bypass a zone using the console (or over the phone) it will STAY bypassed until you RESTORE it. The console status display will show that the zone is bypassed.

To bypass a zone, press the * key after pressing any of the SECURITY keys, then enter the zone number to bypass, then ENTER, then your master code number.

For example, to arm the system in AWAY mode and bypass zone 2, press AWAY, *, 2, ENTER, then enter your master code number.

You can also scroll through the zones if you do not know which zone number it is.

For example, to arm in the ASLEEP mode with the UPSTAIRS WINDOW bypassed, press ASLEEP, *, SHOW (repeat until the display shows UPSTAIRS WINDOW), ENTER,

13