Home Automation 1503 owner manual Home Automation, Inc, Programs for “when security off ”

Home Automation, Inc.

(like a programmable thermostat), and by buttons - for example, your mode of security. Therefore, your temperatures are adjusted for your real-life schedule for maximum comfort and energy savings.

Following is a programming ex- ample for temperature control based on security modes and button 1, which we call “Vacation”.

Programs for “when security off:”

-PROG, *, 175 (when security off), ENTER: UNIT-NUMBER, 17, OFF. (Turns energy saver off when you disarm security so your thermostat works normally.

-*, 175, ENTER: UNIT-NUMBER, 17, *(lo temp) 65. (Sets winter set- back temperature.)

-*, 175, ENTER: UNIT-NUMBER, 17, #(hi temp) 85. (Sets summer set- back temperature.)

Programs for “when asleep:”

-*, 177, ENTER: UNIT-NUMBER, 17, ON. (Turns on energy saver when asleep.)

Programs for “when away:”

-*, 178, ENTER: UNIT-NUMBER, 17, ON. (Turns on energy saver when away.)

Programs for “Vacation:”

-*, 1, ENTER: UNIT-NUMBER, 17, *, 50. (Sets vacation mode winter setback)

-*, 1, ENTER: UNIT-NUMBER, 17, #, 86. (Sets vacation mode summer setback)

-*, 1, ENTER: AWAY, master code. (Arms security and turns on en- ergy saver when you go into va- cation mode).

You may wish to add timed com- mands to change the setback tem- peratures and on/off status of the energy saver modules to complete your control strategy.

USING TEMPERATURES TO CONTROL APPLIANCES

It is possible to set high and low setpoints on all temperature zone types. The temperature zone types are:

-Programmable energy saver module (PESM) (Type 80)

-Outdoor temperature (Type 81)

-Temperature (Type 82)

-Temperature alarm (Type 83)

The setpoints are set as de- scribed for programmable energy saver modules. The zone type is set up during installation by your dealer.

Each of the setpoints may be set from 0 to 120 degrees. Setting a setpoint to 0 degrees disables that setpoint. The high setpoint must always be at least four degrees higher than the low setpoint if both setpoints are used.

46