Home Automation 1503 owner manual Home Automation, House

Home Automation,

This delay is set at the factory to 15 seconds. We recommend a mini- mum time of 15 seconds to preclude an accidental activation of the alarm from calling in a false alarm.

To set the dial out delay, enter the desired dial out delay in seconds, then press ENTER.

HOUSE CODE

The HOUSE CODE is for the X-10 Powerhousetm modules used to con- trol lights and appliances in your home. The HOUSE CODE must be set to the same HOUSE CODE as all of your modules. We suggest setting it to an initial of your name (i.e. J for John.)

The HOUSE CODE is used to pre- vent interference from neighboring systems using X-10 Powerhousetm modules. For example, if your next door neighbor has a system, then his should be set to a HOUSE CODE different from yours.

To change the house code, press one of the following numbers to enter the HOUSE CODE you want, then press the ENTER key.

Number	HOUSE	Number
HOUSE
		CODE
CODE
1	A	9	I
2	B	10	J
3	C	11	K
4	D	12	L
5	E	13	M
6	F	14	N
7	G	15	O
8	H	16	P

The Model 1503 uses this house code for unit numbers 1 - 16.

In Model 1503 Version 2 systems, Unit numbers 80 - 96 are automati- cally assigned to the next consecu- tive house code. For example, if you set the Model 1503 House Code to B, then unit numbers 1 - 16 will be on house code B. Unit numbers 80 - 96 will correspond to modules set to 1-16 on house code C. Unit numbers 97 - 112 will correspond to module set to 1 - 16 on house code D. Unit numbers 113 - 128 will correspond to modules set to 1 - 16 on house code E.

HELP MESSAGES

To remind you of how to change the next item, there are help mes- sages built into the system. Press SHOW to continue past the help message.

The help message says: “For the next item, 0=None, 1-128=unit #, 129 = ALL LIGHTS. Press ENTER after each entry and again when done.”

70