Home Automation owner manual The default for FREEZE ALARM ENABLED is NO, Model 1503 Owners

amount. The calculated time of sunrise/sunset will change by four minutes for every degree change in longitude. To cause the calculated sunrise/sunset to occur later, enter a larger value for longitude. Enter a smaller value for longitude to cause the time to occur earlier.

It is not necessary to alter the time zone to compensate for day- light savings time, since the sys- tem requires you to specify when the time is set up whether daylight savings time is in effect.

FREEZE ALARM ENABLED:

If there are one or more Model 1101 PESMs in a system, they can also be used to detect a freeze condition. See FREEZE ALARM.

To enable freeze alarm detection, press 1, ENTER. To disable this feature, press 0, ENTER.

The default for FREEZE ALARM ENABLED: is NO.

FREEZE ALARM ENABLED is the last entry in the MISCELLANEOUS cat- egory.

DIAL CATEGORY (VOICE DIALER)

To view or change items in the DIAL category, press the SET-UP key, then the DIAL key. To see the next item in this category, press SHOW. To see the previous item, press SET-UP.

To exit the set-up facility, press

CANCEL.

Model 1503 Owner's

TELEPHONE ACCESS

The TELEPHONE ACCESS item allows you to turn the local (in-house) and remote telephone control fea- ture on and off.

If set to ON, the Model 1503 will allow local and remote tele- phone access as described in TELE- PHONE CONTROL. If set to OFF, the Model 1503 will not answer incoming calls ever, and will not work on the in house phones.

Dial outs will still occur, and the system will operate normally when the Model 1503 dials out.

If you do not have your Model 1503 connected to a phone line, set TELEPHONE ACCESS to OFF to keep the system from displaying ‘PHONE LINE DEAD TROUBLE NOW’.

To turn TELEPHONE ACCESS off, press 0 then ENTER. To turn it back on, press 1 then ENTER.

The default setting for TELE- PHONE ACCESS is ON.

ANSWER OUTSIDE CALL?

If you do not want your system to answer outside calls, set this item to NO. The local (in-house) telephone control features will still work, but the system will never answer an incoming call.

To set ANSWER OUTSIDE CALL? to NO, press 0 then ENTER. To turn it back on, press 1 then ENTER.

The default setting for ANSWER OUTSIDE CALL? is YES.

73