Home Automation 1503 Home Automation, Inc, Automatic Calculation Of Sunrise/ S U N S E T

Home Automation, Inc.

ON.

The display will now read “BED- ROOM LIGHT ON - 12:00 AM 11/08 *IF”. This is the program that you are preparing to enter, which is, “Turn BEDROOM LIGHT On at 12:00 AM on date 11/08.”

The Model 1503 assumes the time of 12:00 AM, and uses today’s date as a default for the program date. The *IF is for conditionals. Ig- nore it for now.

Press the TIME key to change the time. The display will read “TIME: 12:00 AM - HHMM AM PM”. Press 6, 0, 0, PM.

NOTE: On Model 1503 systems us- ing 24 hour format, enter the 24 hour time then press ENTER. For example, 1, 8, 0, 0, ENTER.

The display now reads “BEDROOM LIGHT ON 6:00 PM 11/08”.

If you wish to change the time again, you can press the time key again and re-enter the time. You can exit the programming mode at any time by pressing CANCEL. The program you were working on will not be entered into memory.

Since 6:00 PM is what we want, press

ENTER.

The console beeps to indicate that the program has been stored and returns to the PROGRAM menu to allow you to program the next item.

Unit number 4 (BEDROOM LIGHT) will now be turned on at 6:00 PM today. When it does, the program that you entered will automatically be deleted from memory, since it was a one time program.

TO SEE YOUR PROGRAM, press CANCEL to exit the program menu and return to the time, date and status display. Now press SHOW, PROG, UNIT-NUMBER, 4 (or the SHOW key 4 times), ENTER. “BEDROOM LIGHT ON 6:00 PM 11/08” should be shown on the display. (SeeSHOW PROGRAMSfor more information on this function.) Press CANCEL to return to the TIME, DATE and STATUS display.

AUTOMATIC CALCULATION OF SUNRISE/ S U N S E T

The system automatically calcu- lates the time of sunrise and sun- set each day. (See SET-UP, MISC.) Sunrise/sunset can be specified as the time a scheduling command is executed.

To display the calculated time of sunrise or sunset, at the time, date and status display press the AM (for sunrise) or PM (for sunset) key.

The requested time will be dis- played for three seconds then the system will return to the time, date and status display.

When entering a time, the AM or PM key may be pressed before any numbers are entered to specify that the calculated time of sunrise or sunset for that day should be used for the time.

EXAMPLE 2. Program Unit 2 (front porch light) OFF at SUNRISE tomor- row (11/09).

From the time, date and status display (press CANCEL to get there, you may have to press CANCEL twice depending on where you were)

Press PROG, UNIT-NUMBER, 2, OFF.

34