Onkyo TX-NR809 Controlling Zone 2/3 Components, Operating on the remote controller, 8RECEIVER

Controlling Zone 2/3 Components	■ Operating on the remote controller
	To control Zone 2/3, you must press the remote
■ Operating on the AV receiver	controller’s ZONE first.
Input selector buttons	ZONE turns red while Zone 2 is on, and green while
	Zone 3 is on.
MASTER VOLUME
	8RECEIVER
	ZONE

ZONE 3

ZONE 2 OFF

1 To turn on Zone 2/3 and select an input source, press ZONE 2 or ZONE 3 followed by an input selector button within 8 seconds.

Zone 2/3 turns on, the Z2/3 indicator lights on the display.

Tip

• The corresponding trigger output goes high (+12 V).

To select AM or FM, press TUNER input selector and ZONE 2 or ZONE 3 repeatedly.

To select the same source as the main room’s, press ZONE 2 or ZONE 3 twice. “Z2 Selector: Source” or “Zone 3 Selector: Source” appears on the display.

To turn off Zone 2/3, press ZONE 2 or ZONE 3. The Z2/3 indicator on the display flash. Press OFF.

The zone is turned off.

Tip

• The corresponding trigger output goes low (0 volts).

Input selector buttons

MUTING

VOLq/w

1 Press ZONE repeatedly, then point the remote controller at the AV receiver and press

8RECEIVER.

Zone 2/3 turns on, the Z2/3 indicator lights on the display.

Tip

• The corresponding trigger output goes high (+12 V).

2 To select an input source for Zone 2/3, press ZONE repeatedly, followed by INPUT SELECTOR.

To select AM or FM, press the TUNER input selector and ZONE repeatedly.

Note

•You cannot select different AM or FM radio stations for your main room and Zone 2/3. The same AM/FM radio station will be heard in each room.

3 To turn off Zone 2/3, press ZONE repeatedly, followed by 8RECEIVER.

Tip

• The corresponding trigger output goes low (0 volts).

En

67