Onkyo Guide to Automatic Speaker Setup for Receivers

TX-NR702,602_En.book Page 39 Monday, July 26, 2004 11:05 AM

First Time Setup
This chapter explains the settings that you need to make before using the AV receiver.
Automatic Speaker Setup		2	Put the speaker setup micro-
With the supplied speaker setup microphone, the Auto-			phone in the listening position,
			and connect it to the SETUP MIC
matic Speaker Setup function can measure the test tone
			jack.
output by each speaker and automatically determine the
number of speakers connected, their sizes, the distance
from each speaker to the listening position, and so on.
Before using this function, connect and position all your				MIC
speakers.				position
				Auto Speaker Setup
				------------------------
				Push Enter:Start
1	2
	3–7		Notes:
			• Wait at least five seconds after turn-
				ing on the AV receiver before plug-
				ging in the speaker setup
				microphone.
			•	Make sure the microphone is hori-
				zontal.
			• If there’s an obstacle between the
1	Turn on the AV receiver and the			microphone and any speaker, the
				automatic setup will not work cor-
	connected TV.
				rectly. Set the room how you would
	On the TV, select the input to which the
				have it when enjoying a DVD.
	AV receiver is connected.
			• If the AV receiver was previously
				muted, the Muting function will be
				cancelled.
			•	The automatic setup cannot be used
				while a pair of headphones is con-
				nected.
			• By putting the microphone close to
				where your ears would normally be
				at the listening position, a more accu-
				rate setup can be achieved. If you use
				a tripod or level table, you can adjust
				the height of the microphone.

39