Onkyo TX-SR8260 Minimum Speaker Impedance not American models, Buttons to select b. Sp Imped

TX-NR702,602_En.book Page 44 Monday, July 26, 2004 11:05 AM

First Time Setup—Continued

Minimum Speaker Impedance (not American models)

This setting is not set automatically by the Automatic Speaker Setup function (see page 39).

If the impedance of any of the connected speakers is 4 ohms or more, but less than 6 ohms, set the Minimum Speaker Impedance to “4 ohms.”

Note:

Before you change this setting, turn down the volume.

2	Use the Up and Down [ ]/[ ]
	buttons to select “1. Initial
ENTER	Setup,” and then press [ENTER].
	The Initial Setup menu appears.

ENTER

1

3

ENTER

ENTER

Use the Up and Down []/[ ] buttons to select “3. Hardware Setup,” and then press [ENTER].

The Hardware Setup menu appears.

Menu
------------------------
Basic Setup
1.Initial Setup	-
1-----------------------.Initial Setup

1.Digital Input
1-3.Hardware Setup
------------------------2.Component Video
Advanced Setup
3a..HardwarePowered Zone2Setup
3.Surround Setup
:Not Activated
4.Audio Adjust
b.Sp Impedance Minimum
5.Listening Mode Preset
6.Preference	:6ohms
c.TV Format	:NTSC
d.AM Frequency Step
	: 9kHz

2, 3

2–4

1, 5

	(Menus vary depending on country.)
4	Use the Up and Down [ ]/[ ]
	buttons to select “b. Sp Imped-

ance Minimum,” and then use the

ENTER

Left and Right []/[ ] buttons to select:

4 ohms: Select if the impedance of any connected speaker is 4 ohms or more, but less than 6 ohms.

6 ohms: Select if the impedances of all connected speakers are between 6 and 16 ohms.

5	Press the [SETUP] button.
	The setup menu closes.

1

RECEIVER

Press the [RECEIVER] button fol- lowed by the [SETUP] button.

The main menu appears onscreen.

Notes:

•This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button.

44