Onkyo TX-SR8260, TX-SR602/602E, TX-SR702/702E instruction manual Crossover

TX-NR702,602_En.book Page 47 Monday, July 26, 2004 11:05 AM

First Time Setup—Continued

6	Use the Up and Down [ ]/[	]
	buttons to select “c. Center,” and
	then use the Left and Right [	]/
	ENTER

[ ] buttons to select:

Small: Select if the center speaker is small.

Large: Select if the center speaker is large.

None: Select if no center speaker is connected.

Note:

•If the Front setting in step 5 is set to Small, the Large option cannot be selected.

7	Use the Up and Down [ ]/[ ]
	buttons to select “d. Surround,”

9	Use the Up and Down [ ]/[ ]
	buttons to select “f. SurrBack

ch,” and then use the Left and

ENTER Right [ ]/[ ] buttons to select:

1ch: Select if one surround back

speaker is connected.

2ch: Select if two (left and right) surround back speakers are connected.

Continue with step 10 in the right col- umn.

Crossover

and then use the Left and Right

ENTER

[]/[ ] buttons to select:

Small: Select if the surround left and right speakers are small.

Large: Select if the surround left and right speakers are large.

None: Select if no surround left and right speakers are connected.

Note:

•If the Front setting in step 5 is set to Small, the Large option cannot be selected.

8	Use the Up and Down [ ]/[ ]
	buttons to select “e. Surround

Back,” and then use the Left and

ENTER

Right []/[ ] buttons to select:

Small: Select if the surround back left and right speakers are small.

Large: Select if the surround back

speakers are large.

None: Select if no surround back speakers are connected.

Notes:

•If the Surround setting in step 7 is set to None, this setting cannot be selected.

•If the Surround setting in step 7 is set to Small, this setting cannot be set to Large.

10

ENTER

Use the Up and Down []/[ ] buttons to select “g. Crossover,” and then use the Left and Right []/[ ] buttons to select a crossover frequency.

Choose a crossover frequency suitable for your setup. If you’re using a sub- woofer, choose a crossover frequency based on the diameter of your front speakers. If you’re not using a sub- woofer, use the diameter of any speaker that you specified as Small.

For the TX-SR702/702E, if you’re using THX-certified speakers, select 80Hz (THX).

Speaker cone	Crossover
diameter	frequency
Over 12 in.	40Hz*
(30 cm)
8 to 12 in.	60Hz
(20–30 cm)
6-1/2 to 8 in.	80Hz (THX)
(16–20 cm)
5-1/4 to 6-1/2 in.	100Hz
(13–16 cm)
3-1/2 to 5-1/4 in.	120Hz
(9–13 cm)
Under 3-1/2 in.	150Hz
(9 cm)

*TX-SR702/702E only.

Continue with step 11 on the next page.

Notes:

•If the crossover frequency is set to a low value, and the program material doesn’t contain any sounds below that frequency, the subwoofer will not output much sound.

47