Onkyo TX-SR602/602E Basic Operation, Using the Sleep Timer, Setting the Display Brightness

TX-NR702,602_En.book Page 54 Monday, July 26, 2004 11:05 AM

Basic Operation—Continued
		Using the Sleep Timer
		With the sleep timer, you can set the AV receiver to auto-
		matically turn off after a specified period.
Press			Press the [RECEIVER] button,
			and then press the [SLEEP] but-
[RECEIVER]		RECEIVER
first			ton repeatedly to select the
DIMMER	SLEEP		required sleep time.
			The sleep time can be set from 90 to 10
		SLEEP
			minutes in 10 minute steps.
			The SLEEP indicator appears on the
	MUTING		display when the sleep timer has been
			set, as shown. The specified sleep time
			appears on the display for about five
			seconds, then the previous display
			reappears.
Setting the Display Brightness		If you need to cancel the sleep timer, press the [SLEEP]
		button repeatedly until the SLEEP indicator disappears.
You can adjust the brightness of the display.		To check the time remaining until the AV receiver sleeps,
	Press the [RECEIVER] button,	press the [SLEEP] button. Note that if you press the
RECEIVER		[SLEEP] button while the sleep time is being displayed,
	and then press the [DIMMER]	you’ll shorten the sleep time by 10 minutes.

button repeatedly to select:

DIMMER

•Normal+VOLUME light on.

•Normal+VOLUME light off.

•Dim+VOLUME light off.

•Dimmer+VOLUME light off.

Using Headphones

You can connect a pair of stereo headphones (1/4-inch phone plug) to the AV receiver’s PHONES jack for pri- vate listening, as shown.

Muting the AV receiver

You can temporarily mute the output of the AV receiver.

Press the [RECEIVER] button,

RECEIVER and then press the [MUTING] but- ton.

The output is muted and the MUTING indicator flashes on the display, as shown.

MUTING

To unmute the AV receiver, press the [MUTING] button again, or adjust the volume.

The Mute function is cancelled when the AV receiver is set to Standby.

54

PHONES

Notes:

•Always turn down the volume before connecting your headphones.

•The speakers are turned off while the headphones plug is inserted in the PHONES jack. (Zone 2 speakers are not turned off.)

•When you connect a pair of headphones, the listening mode is set to Stereo, unless it’s already set to Stereo, Mono, Direct, or Pure Audio (not American TX-SR602). When you disconnect the headphones, the previous listening mode is resumed.

•Only the Stereo, Direct, Pure Audio (not American TX-SR602), and Mono listening modes can be used with headphones. (The listening modes available also depends on the currently selected input source.)

•When the multichannel input is used, only the front left and right audio can be heard in the headphones. On the TX-SR702E, when the Stereo or Mono listen- ing mode is selected, audio is downmixed for a good sound.