Onkyo TX-SR602/602E TV Format Setup not American models, AM Frequency Step Setup some models only

TX-NR702,602_En.book Page 45 Monday, July 26, 2004 11:05 AM

First Time Setup—Continued

TV Format Setup (not American models)

Here you can specify the TV format used in your area.

1	Press the [RECEIVER] button fol-
RECEIVER	lowed by the [SETUP] button.
	The main menu appears onscreen.

2 Use the Up and Down []/[ ] buttons to select “1. Initial Setup,” and then press [ENTER]. The Initial Setup menu appears.

AM Frequency Step Setup (some models only)

Here you can specify the AM frequency step used in your area. When this setting is changed, all radio presets are deleted.

1	Press the [RECEIVER] button fol-
RECEIVER	lowed by the [SETUP] button.
	The main menu appears onscreen.

2	Use the Up and Down [ ]/[ ]
	buttons to select “1. initial

3

ENTER

ENTER

Use the Up and Down []/[ ] buttons to select “3. Hardware Setup,” and then press [ENTER].

The Hardware Setup menu appears.

Menu
------------------------
Basic Setup
1.Initial Setup	-
1-----------------------.Initial Setup

1.Digital Input
1-3.Hardware Setup
------------------------2.Component Video
Advanced Setup
3a..HardwarePowered Zone2Setup
3.Surround Setup
:Not Activated
4.Audio Adjust
b.Sp Impedance Minimum
5.Listening Mode Preset
6.Preference	:6ohms
c.TV Format	:NTSC
d.AM Frequency Step
	: 9kHz

	Setup,” and then press [ENTER].
	The Initial Setup menu appears.
3	Use the Up and Down [ ]/[ ]
	buttons to select “3. Hardware
ENTER	Setup,” and then press [ENTER].
	The Hardware Setup menu appears.
	Menu
	------------------------
	Basic Setup
	1.Initial Setup		-
	1-----------------------.Initial Setup
ENTER	1.Digital Input
	1-3.Hardware Setup
	2------------------------.Component Video
	Advanced Setup
	3.aHardware.Powered SetupZone2
	3.Surround Setup
	:Not Activated
	4.Audio Adjust
	b.Sp Impedance Minimum
	5.Listening Mode Preset
	6.Preference	:6ohms
	c.TV Format	:NTSC

	(Menus vary depending on country.)
4	Use the Up and Down [ ]/[ ]
	buttons to select “c. TV Format,”

and then use the Left and Right

ENTER

[]/[ ] buttons to select:

Auto: Conforms with the video input signal.

PAL: Select if the TV system in your area is PAL.

NTSC: Select if the TV system in your area is NTSC.

5	Press the [SETUP] button.
	The setup menu closes.

	d.AM Frequency Step
	: 9kHz
4	Use the Up and Down [ ]/[ ]
	buttons to select “d. AM Fre-
	quency Step,” and then use the
	ENTER
	Left and Right [ ]/[ ] buttons to

select:

10 kHz: Select if 10 kHz steps are used in your area.

9 kHz: Select if 9 kHz steps are used in your area.

5	Press the [SETUP] button.
	The setup menu closes.

Note: Note:

•This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button.

•This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button.

45