Onkyo TX-SR602/602E Changing the Remote Controller’s ID, OSD Setup, Remote Setup, Digital Format

6_Advnced_En Page 75 Monday, July 26, 2004 1:58 PM

Advanced Setup—Continued

6-3. OSD Setup

■a. Immediate Display

This preference determines whether or not actions, such as selecting an input source, are displayed onscreen. Normal: Select if your TV is 4:3.

Wide: Select if your TV is 16:9. Off: Actions not displayed.

Even if this preference is set to Normal or Wide, actions are not displayed on the TV or projector that’s connected to the COMPONENT VIDEO OUT.

■b. Scan Mode

If the text in onscreen setup menus flickers due to com- patibility with the connected display device (TV, projec- tor, etc), set the Scan Mode to Non-Interlaced.

Interlaced:Default.

Non-Interlaced:Select if the text flickers.

•Depending on the display device, when Non-Inter- laced is selected, the onscreen setup menus may not appear. If this happens, use the AV receiver’s display and repeat the procedure to revert to Interlaced.

6-4. Remote Setup

■a. Remote ID

With this setting, you can change the AV Receiver’s remote control ID. You may need to change this if the remote controller’s control codes overlap with those of another Onkyo component located in the same room.

•If you change the AV receiver’s remote control ID, be sure to set the same ID on both the AV receiver and remote controller (see right column). The default ID for both is 1.

■b. IR IN Position

When using a commercially available IR receiver, use this setting to specify its location.

Main: Select if the IR receiver is located in the main room.

Zone 2: Select if the IR receiver is located in, and will be used to control Zone 2.

6-5. Digital Format

This setting does not apply to input selectors not assigned to a digital input jack.

With this setting, you can set a digital input to DTS, PCM, or Auto. This can be set for each input selector individually.

Use the Up and Down [ ]/[ ] buttons to select the input selector that you want to set, and then use the Left and Right [ ]/[ ] buttons to select:

Auto: PCM, Dolby Digital, and DTS formats are accepted. If no digital signal is present, the ana- log input is used.

DTS: Select this option if playing a DTS CD with the Auto option produces noise while the AV

receiver is identifying the DTS signal, or when using fast forward or fast reverse. Nothing is output if the input signal is not DTS.

PCM: Select this option if playing a CD or other PCM source with the Auto option causes the tops of tracks to be clipped. Nothing is output if the input signal is not PCM.

•If there is no digital connection, only Auto appears.

•Select Auto or DTS when playing a DTS CD or LD. If you select PCM, only noise will be heard.

Changing the Remote Controller’s ID

If several Onkyo components are used in the same room, the remote controller’s control codes may overlap with those of another component. To differentiate the remote controller’s control codes, you can change its ID to another number.

Notes:

If you change the remote controller’s ID, be sure to set the same ID on both the remote controller and AV receiver (see 6-4. Remote Setup in the left column). The default ID for both is 1.

1

Number

buttons

1

1	Press and hold down the [RECEIVER]
	button, and then press the TV [INPUT]
	button.
2	Use the number buttons to enter a remote
	control ID.

You can enter 1, 2, or 3.

75