Onkyo TX-SR8260, TX-SR602/602E Speaker Level Calibration, Buttons to select 2. Speaker

TX-NR702,602_En.book Page 50 Monday, July 26, 2004 11:05 AM

First Time Setup—Continued

Speaker Level Calibration

This setting is set automatically by the Automatic Speaker Setup function (see page 39).

Here you can adjust the level of each speaker with the built-in test tone so that the volume of each speaker is the same at the listening position.

Notes:

•The speakers cannot be calibrated while the output of the AV receiver is muted, while a pair of headphones is connected, or when using the multichannel input.

•Because the TX-SR702/702E supports THX, the test tone is output at the standard level of 0 dB (absolute volume setting 82). If you normally listen at volume settings below this, be careful because the test tone will be much louder.

3

ENTER

ENTER

Use the Up and Down []/[ ] buttons to select “3. Level Cali- bration,” and then press [ENTER].

The Level Calibration menu appears and the pink noise test tone is output by the front left speaker.

Menu

------------------------
Basic Setup
2.Speaker Setup	-
1-----------------------.Initial Setup

1.Speaker Config
2-34.LeveEqualizerCalibraSettionngs
2.Speaker Distance------------------------
Use Settings	:Manual
Advanced	:	0dB
3.a.Left
4 b.Center Left	:	0dB
ca.Rught80Hz	:	0dB
5.Listening Mode Preset
db.Surr250HzRight	:	0dB
6.Preference
ec.Surr800HzBack R	:	0dB
fd.Surr2.5kHzBack L	:	0dB
ge.Surr8kHzLeft	:	0dB
h.Subwoofer	:	0dB

1

2, 3

2–4

1, 6

1	Press the [RECEIVER] button fol-
RECEIVER	lowed by the [SETUP] button.
	The main menu appears onscreen.

2	Use the Up and Down [ ]/[ ]
	buttons to select “2. Speaker
ENTER	Setup,” and then press [ENTER].
	The Speaker Setup menu appears.

Note:

Speakers that you set to No or None on the Speaker Configuration page (page 46) cannot be selected.

4	Use the Up and Down [ ]/[	]
	buttons to select each speaker,
	and use the Left and Right [	]/

ENTER

[ ] buttons to set the volume. The volume can be adjusted from –12 to +12 dB in 1 dB steps (–15 to +12 dB for the subwoofer).

5	Repeat step 4 until the volume of
	the test tone from each speaker
	is the same.
6	Press the [SETUP] button.
	The setup menu closes.

Notes:

•This procedure can also be performed by using the remote controller. First press the [TEST TONE] but- ton to output the test tone. Use the [LEVEL–] and [LEVEL+] buttons to set the volume, and use the [CH SEL] button to select the speakers.

ENTER

50