Polaroid Polaview 220 manual Connector panel, Computer Inputs Outputs Stereo L R Redrive RS

Page 14

10Detailed setup

Connector panel

All connections between the projector and your computer or video source are made on the rear connector panel.

The connector panel

SOURCE 1		SOURCE 2
L	R	L	R

VIDEO INPUTS

SOURCE 3	SOURCE 4
STEREO	STEREO
MAC / PC	PC / MAC

COMPUTER INPUTS

OUTPUTS

STEREO L R

REDRIVE RS 232

Input: 120/230V~ 60/50Hz,5.0/2.5A

CAUTION !

For continued protection against the risk of fire, replace only with the same type and rating of fuse.

Double pole / Neutral fusing

Type and Rating: T Slow-blow, 6.3A, 250V-

Note: Whenever you connect the projector to a computer or video source for the first time, the projector defaults to the factory settings. Due to operational differences between computers and video sources, it may be necessary to make minor adjustments to the settings. See Image optimization in Chapter 4, Using the projector for more information. The projector stores any modified settings and defaults to them when you turn the power off and on again.

Image 14

Contents Polaview Regarding safety, public health, environment Radiate radio frequency energy and, if not installedProtection against such interference when operated in a Specifications are subject to change without noticeTable of contents Storage, cleaning and care Replacing the lamp Appendix a Parts Appendix B StandardsIntroduction What’s in the box? Items included with the projectorComputer/video compatibility Connector panel Quick startIntroduction Introduction Your Polaview Model 220 Projector Detailed setupPolaroid Polaview Model 220 Projector and remote control Polaroid Polaview Model 220 Projector rear view Getting started Connector panel Computer Inputs Outputs Stereo L R Redrive RSComputer and VCR connections To Mac into the computer monitor port. Plug the end Labeled To VGA into the projector MAC/PC port seeVideo source. Connect the yellow plug at the other end Input composite jacks yellow on the projector connectorConnect one of the yellow RCA composite video cable Panel see the illustration belowUse Sources 1 and 2 to connect Supplying power to the projector Power receptacle and AC power switchUsing the projector Turning on the projectorWant to adjust the rear feet of the projector to position On the control panel or remote control. Adjust the imageSize by using the Zoom control on the control panel or Focus the projected image with the Focus control eitherControl-panel keys Adjusts the focus of the image Image, when used with the cursorDecreases or increases the volume Adjusts the brightness and contrastUsing the remote control Laser pointer Serves as a pointing device Controls the volume, balance, trebleBrightness, contrast, tint, phase Bass of the source connected toFocus + Adjusts the focus of the image Zoom + Zooms in and out. Press + to makeMenu selections Or rear projection mode Select the Setup menu to make adjustments toFollowing settings Resets all adjustments toImage optimization Adjust brightness and contrast. The correct combination From the projector control panel or remote control, pressUsing the cursor pad, scroll through the menu selections Examine the projected image for horizontal noise bars orChanges from the default setting are stored in memory for Use the Tint option to make the adjustmentsAdjust the color balance of the projected image Control panel or remote control commands, you canMaintenance Storage, cleaning and careReplacing the lamp assembly Lamp assembly straight out of the unit Unlock the lamp assembly by rotating the locking key onHalf revolution. Grasp the wire handle and gently pull Align the lamp-assembly slide rails with the slide-railSymptom Cause Solution TroubleshootingTroubleshooting guide If at any time you need help Where to get helpYour computer dealer Polaroid Offices and Service Centers BrasilNew Zealand One Year Warranty Maintenance Appendix a Parts Replacement productOptional accessory OG45Appendix a Appendix B Standards