Pioneer PDSP-1 manual Rear Panel

Page 12

Front Panel	Rear Panel	Remote Control Unit

Rear Panel

The main power switch, power cord socket, and input/output connectors are located on the rear panel.

RS-232C connector (used by installation technician)

INPUT 1 COAXIAL

(digital audio input)

INPUT 2 OPTICAL

(digital audio input)

INPUT 3 OPTICAL

(digital audio input)

INPUT 4 OPTICAL

(digital audio input)

OUTPUT OPTICAL

(digital audio output)

Main power switch

Power cord socket

SUB WOOFER 1 OUTPUT

(sub-woofer output 1)

SUB WOOFER 2 OUTPUT (sub-woofer output 2)

INPUT 5

(analog audio inputs)

INPUT 2

(analog audio inputs)

INPUT 2

(video inputs)

INPUT 5

(video inputs)

INPUT 4

(video inputs)

MONITOR OUTPUT

(video outputs)

Turning the Main Power ON/OFF

1Connect the supplied power cord to the rear panel power cord socket, and then insert the plug in a household power outlet.

2Turn the main power ON/OFF by setting the main power switch to the [–] (ON) or [°] (OFF) sides.

Caution:

Do not use any power cord other than the one supplied.

12

Image 12

Contents PDSP-1 Installation Preface For U.S. modelMaintenance of External Surfaces Regarding InstallationContents Features Beam control technologySound settings to match your room’s characteristics Confirm All Accessories These operating InstructionsSpecifications Audio SectionFront Panel Range of the Remote Control Unit Parts and their FunctionsAttaching the Front Grille Rear Panel About the Input/Output Connectors Audio output Output Optical connectorVideo outputs Monitor Output connectors SUB Woofer Output connectorsRemote Control Unit About the Remote Control Unit Buttons hard keysSetting the Basic Information on the Remote Control Unit Set the touch panel to the Home menuIllustration depicts U.S. model Using the Remote Control Unit Using Digital Sound ProjectorComponent Operation Menu Display About the Home Menu About the Pdsp digital sound projector menu Operating Menus for Other Components Using Watching TelevisionWatching a DVD Accompanying three menus are used to operate the DVD playerUsing a Pioneer DVD Recorder RecordingPerform recording operations on menu 1/2 at left Playback/Editing Following four menus are used to operate the DVD recorderSelecting the Audio Mode UsingDigital Sound Pr ojector Plii Movie Plii Music Pro Logic StereoMono Enhancing Monaural SourcesAdjusting the Sound Test SignalChanging Surround Sound Use the touch panel to select the Pdsp menuLeft RightSurround L Surround RSurround Setup Left Aux Center Mute Bass Management Noise Source OffLeft To edit Press Enter or Menu to exit Level 0dB Changing Each Channel’s Output LevelSame as steps 1 3 on P27, Test Signal Bass Management Sub Woofer Yes LFE LevelSub Woofer Menu No/LFE to panel Yes Sub Woofer / Bass ManagementAdjusting the Tone All Ch Tone Control Bass Level 0dBTreble Level 0dB All Ch To edit Press Enter or Menu to exit 0dB Bass +Calling Up a Room Sound Setting Recall from MemoryVideo and Audio Timing Compensations Lipsync delay Lipsync delay To edit Press Enter or Menu to exit Delay 0msAdjusting Surround Effects Stereo Mode Menu Image width Image width value Plii ModePlii Mode Plii Off Movie Music Pro Logic Fine Tuning the Plii Music ModeStereo Mode Menu Image width Panorama Off Center width DimensionStatus Source Input 2 D Memory Mode Displaying the Data ScreenWidth Press the Enter buttonTroubleshooting Additional Information Table of Remote Control Unit Menu Displays Dvdplayer Channel Menu Enter VOLUME,MUTE Index Terms displayed in menus Terms on front panel / rear panelSymbols and terms on remote control unit / touch panel Terminology in these operating instructions03F00001