Pioneer PDSP-1 manual Illustration depicts U.S. model

Page 16

Front Panel

Rear Panel

Remote Control Unit

 

 

 

Recharging the Remote Control Unit

1Connect the accessory AC adapter to the recharger and a household AC outlet.

Note:

Illustration depicts U.S. model.

2Place the remote control unit on the recharger, aligning the indents on the remote control unit with the tabs on the recharger.

Note:

During recharging, the indicator shown below will appear on the upper right corner of the display. Recharging indicator

Caution:

Do not use AC adapters other than the one supplied.

“Can’t recharge remote control unit” ￿ P39

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents PDSP-1 Installation Preface For U.S. modelMaintenance of External Surfaces Regarding InstallationContents Features Beam control technologySound settings to match your room’s characteristics Confirm All Accessories These operating InstructionsSpecifications Audio SectionFront Panel Parts and their Functions Range of the Remote Control UnitAttaching the Front Grille Rear Panel About the Input/Output Connectors Audio output Output Optical connectorVideo outputs Monitor Output connectors SUB Woofer Output connectorsRemote Control Unit About the Remote Control Unit Buttons hard keysSetting the Basic Information on the Remote Control Unit Set the touch panel to the Home menuIllustration depicts U.S. model Using Digital Sound Projector Using the Remote Control UnitComponent Operation Menu Display About the Home Menu About the Pdsp digital sound projector menu Operating Menus for Other Components Using Watching TelevisionWatching a DVD Accompanying three menus are used to operate the DVD playerRecording Using a Pioneer DVD RecorderPerform recording operations on menu 1/2 at left Playback/Editing Following four menus are used to operate the DVD recorderSelecting the Audio Mode UsingDigital Sound Pr ojector Plii Movie Plii Music Pro Logic StereoMono Enhancing Monaural SourcesAdjusting the Sound Test SignalChanging Surround Sound Use the touch panel to select the Pdsp menuLeft RightSurround L Surround RSurround Setup Left Aux Center Mute Bass Management Noise Source OffLeft To edit Press Enter or Menu to exit Level 0dB Changing Each Channel’s Output LevelSame as steps 1 3 on P27, Test Signal Bass Management Sub Woofer Yes LFE LevelSub Woofer Menu No/LFE to panel Yes Sub Woofer / Bass ManagementAdjusting the Tone All Ch Tone Control Bass Level 0dBTreble Level 0dB All Ch To edit Press Enter or Menu to exit 0dB Bass +Calling Up a Room Sound Setting Recall from MemoryVideo and Audio Timing Compensations Lipsync delay Lipsync delay To edit Press Enter or Menu to exit Delay 0msAdjusting Surround Effects Stereo Mode Menu Image width Image width value Plii ModePlii Mode Plii Off Movie Music Pro Logic Fine Tuning the Plii Music ModeStereo Mode Menu Image width Panorama Off Center width DimensionStatus Source Input 2 D Memory Mode Displaying the Data ScreenWidth Press the Enter buttonTroubleshooting Additional Information Table of Remote Control Unit Menu Displays Dvdplayer Channel Menu Enter VOLUME,MUTE Index Terms displayed in menus Terms on front panel / rear panelSymbols and terms on remote control unit / touch panel Terminology in these operating instructions03F00001
Top Page Image Contents