Pioneer PDSP-1 manual About the Input/Output Connectors, Audio output Output Optical connector

Front Panel Rear Panel Remote Control Unit

About the Input/Output Connectors

Caution:

Before making or changing the connections, switch off the power and disconnect the power cord from the AC outlet.

Audio output (OUTPUT OPTICAL connector)

Use to connect MD recorders, CD recorders and other digital recording components. These connectors output the digital signals from inputs 1 to 4.

Video outputs (MONITOR OUTPUT connectors)

Use to connect a television monitor or other video component.

Note:

The selection of S or composite connectors should match the selection on the signal input side. (If an S2 video input is used, use the S output connector; if the input is composite, use the composite output connector as well).

SUB WOOFER OUTPUT connectors

Up to two sub-woofers can be connected.

Note:

Sub-woofers reproduce very low-frequency sound; coupled with the LFE (Low-Frequency Effect) channels encoded in Dolby digital and DTS audio sources, these speakers produce sounds effects which heighten the impact and realism of motion picture sound tracks and other sources.

INPUT 1 – 5 connectors

The digital sound projector is equipped with 5 input connector systems which can be combined in the ways

shown below. The various inputs can be selected by using the to or buttons on the remote control unit.

INPUT	Audio Connector	Video Connector
1	Coaxial digital	– (no video)
2	Optical digital/analog	S / Composite
3	Optical digital	– (no video)
4	Optical digital	S / Composite
5	Analog	S / Composite

Note:

Input 2 provides for automatic sensing of digital and analog sources. In the event that both digital and analog signals are simultaneously input to the digital sound projector, the digital signal is given priority.

Parts and their Functions

13