Pioneer PDSP-1 manual Watching a DVD, Accompanying three menus are used to operate the DVD player

Page 22

	Using the Remote	Watching Television	Watching a DVD	Using a Pioneer DVD	Selecting the Audio
	Control Unit	Watching Television	Watching a DVD	Recorder	Mode
	Control Unit			Recorder	Mode

Watching a DVD

Use this menu to operate a connected DVD player.

1

Turn on the power to the digital sound projector.

2

Turn on the power to the television monitor.

3

Set television input to digital sound projector.

4 – ,

Select the input connected to the DVD player.

5

Change to DVD player operating menu.

6The accompanying three menus are used to operate the DVD player.

Use the arrows on the touch panel to change between the menu screens.

DVD Player Operating Menus (3 screens)

1/3	2/3	3/3
1/3	2/3	3/3

Notes:

If a Pioneer DVD player is connected, the DVD player’s power will turn on in step

If is pressed in step 1 , the DVD player operating menus shown in step 6 possible to operate the DVD player without using the digital sound projector.

5.

will appear, and it will be

“INPUT 1 – 5 connectors” P13

22

Image 22

Contents PDSP-1 Installation Preface For U.S. modelMaintenance of External Surfaces Regarding InstallationContents Features Beam control technologySound settings to match your room’s characteristics Confirm All Accessories These operating InstructionsSpecifications Audio SectionFront Panel Parts and their Functions Range of the Remote Control UnitAttaching the Front Grille Rear Panel Video outputs Monitor Output connectors About the Input/Output ConnectorsAudio output Output Optical connector SUB Woofer Output connectorsRemote Control Unit About the Remote Control Unit Buttons hard keysSetting the Basic Information on the Remote Control Unit Set the touch panel to the Home menuIllustration depicts U.S. model Using Digital Sound Projector Using the Remote Control UnitComponent Operation Menu Display About the Home Menu About the Pdsp digital sound projector menu Operating Menus for Other Components Using Watching TelevisionWatching a DVD Accompanying three menus are used to operate the DVD playerRecording Using a Pioneer DVD RecorderPerform recording operations on menu 1/2 at left Playback/Editing Following four menus are used to operate the DVD recorderDigital Sound Pr ojector Selecting the Audio ModeUsing Plii Movie Plii Music Pro Logic StereoMono Enhancing Monaural SourcesChanging Surround Sound Adjusting the SoundTest Signal Use the touch panel to select the Pdsp menuSurround L LeftRight Surround RLeft To edit Press Enter or Menu to exit Level 0dB Surround Setup LeftAux Center Mute Bass Management Noise Source Off Changing Each Channel’s Output LevelSub Woofer Menu No/LFE to panel Yes Same as steps 1 3 on P27, Test SignalBass Management Sub Woofer Yes LFE Level Sub Woofer / Bass ManagementTreble Level 0dB Adjusting the ToneAll Ch Tone Control Bass Level 0dB All Ch To edit Press Enter or Menu to exit 0dB Bass +Calling Up a Room Sound Setting Recall from MemoryVideo and Audio Timing Compensations Lipsync delay Lipsync delay To edit Press Enter or Menu to exit Delay 0msAdjusting Surround Effects Stereo Mode Menu Image width Image width value Plii ModePlii Mode Plii Off Movie Music Pro Logic Fine Tuning the Plii Music ModeStereo Mode Menu Image width Panorama Off Center width DimensionWidth Status Source Input 2 D Memory ModeDisplaying the Data Screen Press the Enter buttonTroubleshooting Additional Information Table of Remote Control Unit Menu Displays Dvdplayer Channel Menu Enter VOLUME,MUTE Index Terms displayed in menus Terms on front panel / rear panelSymbols and terms on remote control unit / touch panel Terminology in these operating instructions03F00001