Planar PD7170 Operations Commands, Operations Control Commands Function Action on unit

Serial Communications

Table 6-1. Serial Command Key Names and IR Codes (continued)

RS232	Remote Button	IR Code		Description
Keyname
		Set 1	Set 2
asp.narr	(none)	0xA1	0xE1	Apply 4:3 Narrow aspect ratio to the
				active source.
pip.sw	PIP	0xA3	0xE3	Switch to next “PIP Select” state.
pip.1	(none)	0xA4	0xE4	Change “PIP Select” to source 1.
pip.2	(none)	0xA5	0xE5	Change “PIP Select” to source 2.
pip.3	(none)	0xA6	0xE6	Change “PIP Select” to source 3.
pip.4	(none)	0xA7	0xE7	Change “PIP Select” to source 4.
pip.5	(none)	0xA8	0xE8	Change “PIP Select” to source 5.
pip.off	(none)	0xA9	0xE9	Change “PIP Select” to off.
pip.swap	SWAP	0xAA	0xEA	Swap the PIP image with the active
				source image.
pow.tog	(none)	0xAC	0xEC	Toggles between power on and
				power off.
lit.tog	LIGHT	0xAD	0xED	Activates remote backlighting only
				when pressed momentarily. When
				held for five seconds or more, the IR
				code for toggling the projector I/O
				panel light is transmitted.

Operations Commands ➤	Operations commands allow more flexible and direct control of the projector.
	The syntax for operations commands is as follows:
	op <operation> <command>[CR]
	(Precede <operation> and <command> with a space.)
	The command type can be one of 5 functions:
		Operations Control Commands
	Function	Command	Action on unit
	Set	= <value>	Makes the unit take that value.
	Get	?	Asks what the current value is.
	Increment	+	Adds 1 to the current value.
	Decrement	-	Subtracts 1 from the current value.
	Execute	(none)	Performs an action such as a reset.

72 Planar PD7170 Installation/Operation Manual