Optoma Technology XX152 N manual Using the 3D glasses

Installation

NOTE

For more detailed information, please refer to

3D glasses user’s guide.

Using the 3D glasses

.To turn ON 3D glasses: Press the “Power” button and the LED will flash one time indicating the glasses are ready to use 3D mode.

2.Verify that 3D content is being sent to the projector and signal is compat- ible with projector specifications.

3.Turn on the “3D Mode” (DLP-Link/VESA 3D) of the 3D projector. The op- tion is located in the “Display” section of the projector OSD menu.

4.Turn on 3D glasses and verify image appears in 3D without eyestrain.

5.If the image does not appear in 3D, please check 3D device set up well to send out 3D image or not. Or “SBS Mode” should turn on when input signal is 2D 1080i side-by-side and repeat previous steps 1 ~ 4.

6.Close your left eye when 3D Images display. To use projector’s “3D Sync-

Invert” option to optimize your 3D experience. The option is located in the “Display” section of the projector OSD menu.

7.To turn OFF 3D glasses: Press the “Power” button and hold until the LED switches off.

8.For more detailed information, please refer to the 3D glasses user’s guide, or manufacturer's Website.

English 16