Optoma Technology XX152 N manual Image has slanted sides, Image is reversed, Blurry double image

Page 44

Appendices

Image has slanted sides:

If possible, reposition the projector so that it is centered on the screen and below the bottom of the screen.

Use “Display-->V Keystone” from the OSD to make an adjust- ment.

Image is reversed

Select “System-->Projection” from the OSD and adjust the projection direction.

Blurry double image

Press “SBS Mode” button and switch to “Off” to avoid normal 2D image is blurry double image.

Two images, side-by-side format

Press “SBS Mode” button and switch to “SBS” for input signal is HDMI 1.3 2D 1080i side-by-side.

Image does not display in 3D

Check if the battery of 3D glasses is drained.

Check if the 3D glasses is turned on.

When the input signal is HDMI 1.3 2D (1080i side-by-side half), press “SBS Mode” button and switch to “SBS”.

English 44

Image 44
Contents Table of Contents Safety Information Important Safety InstructionClass B emissions limits EnglishPrecautions Do not Usage Notice Eye Safety Warnings Introduction Package OverviewProduct Overview Main UnitConnection Ports Remote Control Backup Remote Control Coin Cell Battery ReplacementInstallation Connect to Computer/NotebookConnect to Video Connect to 3D Video Devices PlayStation 3 Games5 English Using the 3D glasses Powering On/Off the Projector Powering On the ProjectorPowering off the projector Adjusting the Projected Image Adjusting the Projector’s HeightAdjusting Projected Image Position Using PureShift  Adjusting the horizontal image position Adjusting Projection Image Size  PureShift Range DiagramRemote Control User ControlsFrom Hdmi 1 connector From Hdmi 2 connectorFrom VGA connector ThanHow to operate On-screen Display MenusMain Menu Sub Menu Settings Menu TreeDisplay Mode ImageContrast BrightnessSharpness ColorColor Settings Noise ReductionGamma PureEnginePureDetail PureColorPureMotion PureEngine DemoCMS Color Management System Color TemperatureColor Gamut RGB Gain/Bias Color SpaceRGB Channel Use or to select from Normal, Red, Green or Blue channelsDisplay FormatZoom Edge MaskImage Shift Keystone3D Mode 3D 2D3D Format 3D Sync. InvertProjection Lamp SettingMenu Location Test Pattern Background Color12V Trigger a 12V Trigger BUser Controls Lamp Mode Lamp ResetLamp Hour Lamp ReminderLanguage Input SourceSource Lock High AltitudeReset Auto Power OffSignal Troubleshooting Image ProblemsImage has slanted sides Image is reversedBlurry double image Two images, side-by-side formatOther Problems Remote Control ProblemsIf the remote control does not work Projector stops responding to all controlsMessage Power LED Temp LED Lamp LED LED Lighting Messages Power down timer active  Lamp warning  Power off On Screen MessagesReplacing the Lamp Lamp Replacing Procedure Compatibility Modes  Computer Compatibility for PC Computer Compatibility for MAC  3D Input Video Compatibility SBSRS232 Commands and Protocol Function List RS232 Pin AssignmentsRS232 Protocol Function List UART16550 FifoSetup Ceiling Mount Installation Optoma Global Offices Deutschland ScandinaviaKorea JapanRegulation & Safety Notices FCC NoticeOperation Conditions Remarque à l’intention des utilisateurs canadiensDeclaration of Conformity for EU countries Disposal instructions