Optoma Technology XX152 N manual Lamp Hour, Lamp Reminder, Lamp Mode, Lamp Reset

Page 40

User Controls

SYSTEM Lamp Settings

Lamp Hour

Display the cumulative lamp operating time.

Lamp Reminder

Choose this function to show or to hide the warning message when the changing lamp message is displayed. The message will appear up 30 hours before suggested replacement of lamp.

NOTE

“Lamp Mode” can separately have different settings for 2D and 3D.

Lamp Mode

Bright: Choose “Bright” to increase the brightness.

STD: Choose “STD” to dim the projector lamp which will lower power consumption and extend the lamp life.

Image AI

Image AI improves the contrast of the picture by optimizing the brightness of the lamp according to the picture content.

Lamp Reset

Reset the lamp life hour after replacing the lamp.

English 40

Image 40
Contents Table of Contents Safety Information Important Safety InstructionClass B emissions limits EnglishPrecautions Do not Usage Notice Eye Safety Warnings Introduction Package OverviewProduct Overview Main UnitConnection Ports Remote Control Backup Remote Control Coin Cell Battery ReplacementInstallation Connect to Computer/NotebookConnect to Video Connect to 3D Video Devices PlayStation 3 Games5 English Using the 3D glasses Powering On/Off the Projector Powering On the ProjectorPowering off the projector Adjusting the Projected Image Adjusting the Projector’s HeightAdjusting Projected Image Position Using PureShift  Adjusting the horizontal image position Adjusting Projection Image Size  PureShift Range DiagramRemote Control User ControlsFrom Hdmi 1 connector From Hdmi 2 connectorFrom VGA connector ThanHow to operate On-screen Display MenusMain Menu Sub Menu Settings Menu TreeDisplay Mode ImageContrast BrightnessSharpness ColorColor Settings Noise ReductionGamma PureEnginePureDetail PureColorPureMotion PureEngine DemoColor Gamut Color TemperatureCMS Color Management System RGB Gain/Bias Color SpaceRGB Channel Use or to select from Normal, Red, Green or Blue channelsDisplay FormatZoom Edge MaskImage Shift Keystone3D Mode 3D 2D3D Format 3D Sync. InvertMenu Location Lamp SettingProjection Test Pattern Background Color12V Trigger a 12V Trigger BUser Controls Lamp Mode Lamp ResetLamp Hour Lamp ReminderLanguage Input SourceSource Lock High AltitudeSignal Auto Power OffReset Troubleshooting Image ProblemsImage has slanted sides Image is reversedBlurry double image Two images, side-by-side formatOther Problems Remote Control ProblemsIf the remote control does not work Projector stops responding to all controlsMessage Power LED Temp LED Lamp LED LED Lighting Messages Power down timer active  Lamp warning  Power off On Screen MessagesReplacing the Lamp Lamp Replacing Procedure Compatibility Modes  Computer Compatibility for PC Computer Compatibility for MAC  3D Input Video Compatibility SBSRS232 Commands and Protocol Function List RS232 Pin AssignmentsRS232 Protocol Function List UART16550 FifoSetup Ceiling Mount Installation Optoma Global Offices Deutschland ScandinaviaKorea JapanRegulation & Safety Notices FCC NoticeOperation Conditions Remarque à l’intention des utilisateurs canadiensDeclaration of Conformity for EU countries Disposal instructions