Optoma Technology XX152 N manual Lamp Replacing Procedure

Page 49

Appendices

1

2

3

4

Lamp Replacing Procedure:

1.Switch off the power to the projector by pressing the Power button.

2.Allow the projector to cool down at least 30 minutes.

3.Disconnect the power cord.

4.Unlock the lamp cover.

5.Push up and remove the cover.

6.Use a screwdriver to remove the screw from the lamp module.

7.Pull out the lamp module.

To replace the lamp module, reverse the previous steps.

8.Turn on the projector and do “Lamp Reset” after the lamp module is replaced.

Lamp Reset: (i)Press “Menu” -> (ii)Select “System” -> (iii)Select “Lamp Settings” ->(iv)Select “Lamp Reset” -> (v)Select “Yes”.

49 English

Page 48 Page 50
Image 49
Page 48 Page 50
Contents Table of Contents Important Safety Instruction Safety InformationClass B emissions limits EnglishPrecautions Do not Usage Notice Eye Safety Warnings Package Overview IntroductionMain Unit Product OverviewConnection Ports Remote Control Coin Cell Battery Replacement Backup Remote ControlConnect to Computer/Notebook InstallationConnect to Video PlayStation 3 Games Connect to 3D Video Devices5 English Using the 3D glasses Powering On the Projector Powering On/Off the ProjectorPowering off the projector Adjusting the Projector’s Height Adjusting the Projected ImageAdjusting Projected Image Position Using PureShift  Adjusting the horizontal image position  PureShift Range Diagram Adjusting Projection Image SizeUser Controls Remote ControlFrom Hdmi 2 connector From Hdmi 1 connectorFrom VGA connector ThanOn-screen Display Menus How to operateMenu Tree Main Menu Sub Menu SettingsImage Display ModeBrightness ContrastSharpness ColorNoise Reduction Color SettingsGamma PureEnginePureColor PureDetailPureMotion PureEngine DemoColor Gamut Color TemperatureCMS Color Management System Color Space RGB Gain/BiasRGB Channel Use or to select from Normal, Red, Green or Blue channelsFormat DisplayEdge Mask ZoomImage Shift Keystone3D 2D 3D Mode3D Sync. Invert 3D FormatMenu Location Lamp SettingProjection Background Color Test Pattern12V Trigger a 12V Trigger BUser Controls Lamp Reset Lamp ModeLamp Hour Lamp ReminderInput Source LanguageSource Lock High AltitudeSignal Auto Power OffReset Image Problems TroubleshootingImage is reversed Image has slanted sidesBlurry double image Two images, side-by-side formatRemote Control Problems Other ProblemsIf the remote control does not work Projector stops responding to all controlsLED Lighting Messages Message Power LED Temp LED Lamp LEDOn Screen Messages  Power down timer active  Lamp warning  Power offReplacing the Lamp Lamp Replacing Procedure  Computer Compatibility for PC Compatibility Modes Computer Compatibility for MAC SBS  3D Input Video CompatibilityRS232 Pin Assignments RS232 Commands and Protocol Function ListUART16550 Fifo RS232 Protocol Function ListSetup Ceiling Mount Installation Optoma Global Offices Scandinavia DeutschlandKorea JapanFCC Notice Regulation & Safety NoticesOperation Conditions Remarque à l’intention des utilisateurs canadiensDisposal instructions Declaration of Conformity for EU countries
Top Page Image Contents