Optoma Technology XX152 N manual Powering On/Off the Projector, Powering On the Projector

Page 17

Installation

Powering On/Off the Projector

Powering On the Projector

. Remove the lens cap. 

2.Securely connect the power cord and signal cable. When con- nected, the Power LED will turn red.

3.Turn on the lamp by pressing “” button on the side of the projec- tor or on the remote control. The Power LED will fl ash blue. 

The startup screen will display in approximately 30 seconds. The fi rst time you use the projector, you can select your preferred lan- guage from quick menu after the startup screen display.

4.Turn on your source that you want to display on the screen (com- puter, notebook, video player, etc). The projector will detect the source automatically and will display on the screen. If not, push menu button and go to “SETUP”. Make sure that the “Source Lock” has been set to “Off”.

If you connected multiple sources at the same time, press the “Source” key on the remote control to switch between inputs.

1

2

NOTE		POWER
		POWER
	Turn on the	LAMP	STANDBY
	Turn on the	LAMP
	projector fi rst and	TEMP
	then select the	TEMP
	then select the
	signal sources.

7 English

Image 17

Contents Table of Contents Important Safety Instruction Safety InformationClass B emissions limits EnglishPrecautions Do not Usage Notice Eye Safety Warnings Package Overview IntroductionMain Unit Product OverviewConnection Ports Remote Control Coin Cell Battery Replacement Backup Remote ControlConnect to Computer/Notebook InstallationConnect to Video PlayStation 3 Games Connect to 3D Video Devices5 English Using the 3D glasses Powering On the Projector Powering On/Off the ProjectorPowering off the projector Adjusting the Projector’s Height Adjusting the Projected ImageAdjusting Projected Image Position Using PureShift  Adjusting the horizontal image position  PureShift Range Diagram Adjusting Projection Image SizeUser Controls Remote ControlFrom Hdmi 2 connector From Hdmi 1 connectorFrom VGA connector ThanOn-screen Display Menus How to operateMenu Tree Main Menu Sub Menu SettingsImage Display ModeBrightness ContrastSharpness ColorNoise Reduction Color SettingsGamma PureEnginePureColor PureDetailPureMotion PureEngine DemoCMS Color Management System Color TemperatureColor Gamut Color Space RGB Gain/BiasRGB Channel Use or to select from Normal, Red, Green or Blue channelsFormat DisplayEdge Mask ZoomImage Shift Keystone3D 2D 3D Mode3D Sync. Invert 3D FormatProjection Lamp SettingMenu Location Background Color Test Pattern12V Trigger a 12V Trigger BUser Controls Lamp Reset Lamp ModeLamp Hour Lamp ReminderInput Source LanguageSource Lock High AltitudeReset Auto Power OffSignal Image Problems TroubleshootingImage is reversed Image has slanted sidesBlurry double image Two images, side-by-side formatRemote Control Problems Other ProblemsIf the remote control does not work Projector stops responding to all controlsLED Lighting Messages Message Power LED Temp LED Lamp LEDOn Screen Messages  Power down timer active  Lamp warning  Power offReplacing the Lamp Lamp Replacing Procedure  Computer Compatibility for PC Compatibility Modes Computer Compatibility for MAC SBS  3D Input Video CompatibilityRS232 Pin Assignments RS232 Commands and Protocol Function ListUART16550 Fifo RS232 Protocol Function ListSetup Ceiling Mount Installation Optoma Global Ofﬁces Scandinavia DeutschlandKorea JapanFCC Notice Regulation & Safety NoticesOperation Conditions Remarque à l’intention des utilisateurs canadiensDisposal instructions Declaration of Conformity for EU countries