Preface
Projector Installation Notice
¾Place the projector in a horizontal position
The tilt angle of the projector should not exceed 15 degrees, nor should the projector be installed in any way other than the desktop and ceiling mount, otherwise lamp life could decrease dramatically.
¾Allow at least 50 cm (19.69 inch) clearance around the exhaust vent.
(19.69 inch) | (19.69 inch) |
(19.69 inch)
(3.94 inch)
(11.81 inch)
(19.69 inch)
¾Ensure that the intake vents do not recycle hot air from the exhaust vent.
¾When operating the projector in an enclosed space, ensure that the surrounding air temperature within the enclosure does not exceed 0 – 40°C (32– 104°F) while the projector is running, and the air intake and exhaust vents are unobstructed.
¾All enclosures should pass a certified thermal evaluation to ensure that the projector does not recycle exhaust air, as this may cause the device to shutdown even if the enclosure temperature is with the acceptable 0 – 40°C (32– 104°F) range.
Power Safety
¾Only use the supplied power cord.
¾Do not place anything on the power cord. Place the power cord where it will not be in the way of foot traffic.
¾Remove the batteries from the remote control when storing or not in use for a prolonged period.
–iii –