Installation
Precautions
•When mounting the Monitor vertically, it is necessary to adjust the cooling fan speed to provide better heat dissipation. Do not forget to perform this adjustment. (See page 27.)
•When installing the Monitor, be sure to use a dedicated Stand Unit, Wall Mounting Unit, or Monitor Hanger Unit, depending on a particular case. Ask your dealer for installation.
•When installing the Monitor, refer also to the user manual for each option to use. Do not tilt the Monitor rightward, leftward, or backward.
•Route the power cord and connection cables along wall or floor corners to avoid walking on them.
•For good heat dissipation, try to leave the following distances of space (minimum) around the Monitor.
•The ambient temperature of the installation place should be within the range of 0˚C to 40˚C.
•When installing the Monitor in a place, such as near the ceiling, the remote control may not work correctly because of possible effects from the surroundings. If this happens, use the remote control as a wired remote control or move the Monitor where it is free from these effects.
When installing the Monitor on a stand
Front View | Side View |
| |
| 200 (77 /8) |
| 50 |
| (2) |
150 | 150 |
(415/16 ) | (415/16 ) |
| 50 |
| (2) |
| Unit: mm (inch) |
Wall
Take measures against the Monitor from overturning:
To protect against abnormal events such as earthquakes and to prevent unexpected accidents, take appropriate measures for preventing the Monitor from overturning; should it overturn, this could lead to personal injury.
For detailed information, refer to the manual supplied for the stand.
When mounting the Monitor on the wall | When hanging the Monitor from the ceiling |
Front View | Side View |
| 200 (77 /8) |
100 | 100 |
(3 15/16) | (315/16) |
| 50 |
Unit: mm (inch) | (2) |
100 (3 15/16) |
Side View
200
(77 /8)
50
(2)
Unit: mm (inch)
Notes:
•Do not allow the same image (pattern) to be continuously displayed on the screen for a long time; otherwise, the area on the screen corresponding to the image may vary in brightness, leaving an afterimage on the screen. To reduce the afterimage, you can use the Refresh function (see page 29).
•The Monitor is manufactured using very
•Do not install the Monitor in such a way that the Monitor and other AV equipment affect each other adversely. (For example, if a disturbed image or noise due to electromagnetic interference occurs, or if the infrared remote control malfunctions, change the installation place.)
10